User guide

PAGE 3 OF 3
SamsonRope.com | Email [e-mail] | Tel [phone]
12-Strand Eye-and-Eye Tail Splice
SAMSON SPLICING INSTRUCTIONS
© 2012 Samson Rope Technologies, Inc. All rights reserved. S/WD #108294 7/2012
Step 4
After completing Step 3, rotate spliced part of rope 90° and reinsert
end A into spliced area in the same fashion as in Steps 1, 2 and 3.
The splice will now be stitched on 2 planes perpendicular to each
other. Make sure you do not pull the stitching too tight.
Step 5
After stitching at least 3 complete stitches as in Step 3, extract both
ends of the twine together through the same opening in the braid.
Tie them together with a square knot and reinsert back into braid.
For double braids, re-insert the knot between the cover and core.
B
A
A
B
1
23
A
B
123
A
B
Step 1
Pass stitching twine through
spliced area near throat of
eye as shown.
Step 2
Reinsert twine through the
rope. The twine should
cover 2 strands from the
exit point. Pull the twine
snug, but not tight.
Step 3
Continue to reinsert as
shown until you have at
least 3 complete stitches
on each side of the rope.
Each stitch should cross
over 2 strands in the rope.