Specifications
Table Of Contents
- Introduction
- RESOLV 120a Features
- RESOLV 120a Layout
- Setting up the RESOLV 120a
- Operating the RESOLV 120a
- Connecting the RESOLV 120a
- RESOLV 120a Connections
- Introduction
- Caractéristiques des RESOLV 120a
- Présentation des RESOLV 120a
- Configuration des RESOLV 120a
- Utilisation des RESOLV 120a
- Connexion des RESOLV 120a
- Subwoofer mono avec satellites passifs utilisant les entrées haut-parleur
- Subwoofer mono avec satellites passifs utilisant les entrées ligne
- Subwoofer mono avec satellites actifs
- Subwoofers stéréo avec satellites passifs
- Utilisation des RESOLV 120a avec le système de moniteurs Samson DMS80
- Utilisation de la sortie SUB OUT du DMS80
- Utilisation des sorties LINE OUT du DMS80
- Connexion des entrées des RESOLV 120a
- Einleitung
- RESOLV 120a Features
- RESOLV 120a Layout
- RESOLV 120a einrichten
- RESOLV 120a bedienen
- RESOLV 120a anschließen
- RESOLV 120a Anschlüsse
- Introducción
- Características del RESOLV 120a
- Distribución del RESOLV 120a
- Distribución del RESOLV 120a
- Configuración del RESOLV 120a
- Manejo del RESOLV 120a
- Conexión del RESOLV 120a
- Sub mono con satélites pasivos usando las entradas de altavoz
- Sub mono con satélites pasivos usando las entradas de línea
- Sub mono con satélites activos
- Sub stereo con satélites pasivos
- Uso del RESOLV 120a con el sistema de monitorización Samson DMS80
- Uso de la salida SUB OUT del DMS80
- Uso del RESOLV 120a con el sistema de monitorización Samson DMS80
- Uso de las salidas LINE OUT del DMS80
- Conexiones del RESOLV 120a
- Introduzione
- Le Caratteristiche del RESOLV 120a
- RESOLV 120a - I Componenti
- RESOLV 120a - I Componenti
- RESOLV 120a - Configurazione
- L'Uso del RESOLV 120a
- L'Uso del RESOLV 120a
- L'Uso del RESOLV 120a
- Il Collegamento del RESOLV 120a
- Il Collegamento del RESOLV 120a
- Il Collegamento del RESOLV 120a
- Il Collegamento del RESOLV 120a
- Il Collegamento del RESOLV 120a
- Il Collegamento del RESOLV 120a
- RESOLV 120a - Le Connessioni
- Specifications/Caractéristiques techniques/Technische Daten/Especificaciones técnicas/Specifiche

18
Connecting the RESOLV 120a
SPEAKER OUTPUTS
LEFT+
LEFT- RIGHT+RIGHT-
SPEAKER IMPEDANCE 4-8
LINE IN AUX IN
SAMSON
DESKTOP MONITOR SYSTEM STEREO 40W X2 MODEL:DA80
MADE IN CHINA
LINE OUT
SUB OUT
MONO
SERIAL
NUMBER
RISK OF ELECTRIC SHOCK
DO NOT OPE
N
WARNING
DO NOT EXPOSE THIS EQUIPMENT
TO RAIN OR MOISTURE
AVIS
RISQUE DE CHOC ELECTRONIQUE
NE PAS OUVRI
R
CAUTION
FOR CONTINUED PROTECTION AGAINST RISK
OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE
ATTENTION
UTILISER UN FUSIBLE DE
RECHANGE DE MÊME TYPE
RIGHT
LEFT
RIGHT
LEFT
RIGHT
LEFT
INPUT
– +
INPUT
– +
+
–
–
+
10 Inch Long Throw Transducer 120 Watt Amplifier
The RESOLV 120a can be connected to the DMS80 by using the LINE OUTS located on the DMS80’s rear panel. When
using the DMS80’s LINE outputs you will utilize the RESOLV 120a internal electronic crossover, which will allow you
to experiment and fine-tune your monitor system. Follow the diagram and instructions below to interface your new
subwoofer.
• Make the connections between your mixer and your DMS80 monitor system as described in the DMS80’s users man-
ual and make sure that you turn your mixer all the way down.
• Connect the RIGHT and LEFT LINE OUTPUTS located on the rear panel of the DMS80 to the RIGHT and LEFT PREAMP
INPUTS on the RESOLV 120a.
• Turn the RESOLV 120a’s Volume all the way off, and set the SWEEP control to 100Hz.
• Now run some audio, like music on a CD, through your mixer and raise the output to the DMS80 monitor system to a
comfortable listening level.
• Now, slowly raise the RESOLV 120a’s LEVEL control and adjust the low frequency output to your taste. You can exper
-
iment by listening to the difference when adjusting the crossover point with the SWEEP control. Also, listen as you
adjust the balance between the RESOLV 120a and the DMS satellite speakers by changing the RESOLV 120a’s LEVEL
control. Once you find the balance you like, the RESOLV 120a will track the satellites when you raise or lower your
mixer’s output.
USING THE RESOLV 120A WITH THE SAMSON DMS80 MONITOR SYSTEM
Using The DMS80’s LINE OUTs
ENGLISH