Operation Manual

8: Battery compartment -
Insert a standard AA alkaline
battery here, being sure to
observe the plus and minus
polarity markings shown. We
recommend the Duracell type
battery. Although rechargeable
Ni-Cad batteries can be used,
they do not supply adequate
current for more than four
hours. WARNING: Do not
insert the battery backwards;
doing so can cause severe
damage to the AX300 and will
void your warranty.
9: Battery cover - Pull back gently
on this cover at the ribbing and
pry upwards to remove. See the
“Setting Up and Using Your Synth
AirLine Synth System” section on
page 12 in this manual.
10: XLR connector - Connect this
standard female XLR connector
into any standard wired
dynamic microphone in order
to make it a wireless mic.
11: Rubber gasket - If necessary,
use this provided rubber
gasket in order to make a
solid connection between the
AX300 XLR connector and your
microphone (note that not all
microphones require its use).
8 9
Guided Tour - AX300 Transmitter
319
1110
14