Operation Manual

ENGLISH

ESPAÑOLITALIANO FRANÇAISDEUTSCHE

Quick Start

The following steps will help you set up your Auro D1800 active subwoofer.

• Unpack the Auro D1800 and included compo-

nents. Be sure to save the packaging in case you

ever move, or need to send the unit for service.

• Set the Auro D1800 subwoofer and satellite

speaker(s) appropriately for the performance

venue. The D1800 has a 13/8" speaker pole recep-

tacle, so you can mount a satellite speaker on

top of the D1800 using a satellite mounting pole

(such as the Samson TS20).

• Turn the Level control on all speakers fully coun-

terclockwise.

• Turn the Power switch to the OFF position on all

speakers.

• Connect a line-level signal from your mixer (or other source) to the XLR Input jack

on the Auro D1800. If you are using a single subwoofer with stereo satellite speak-

ers, connect the left and right output of the mixer to the stereo XLR Input jacks on

the Auro D1800.

• Connect an XLR cable from the High Pass output of the Auro D1800 to the line

input of your satellite speaker(s).

• Plug the supplied power cable into an AC outlet.

Note: Always make sure that the AC outlet used with this unit is congured with the

correct voltage, as indicated on the rear panel of the Auro loudspeaker.

• Turn the Power switch on your D1800 and satellite speaker(s) to the ON position.

• Run an audio signal (like music from a CD) from your mixer, and check that you are

getting good level using the mixer's output meter.

• Slowly raise the satellite speaker(s) level control until you have reached a comfort-

able level. Then raise the Auro D1800 Level control until you have reached a level

that sits well within the rest of the mix.

• If the volume from the D1800 gets too loud, or you notice the Peak indicator blink-

ing frequently, turn down the Level control on the Auro D1800 a little until the Peak

indicator does not light, or only lights occasionally with signal peaks.

Auro D1800Owner's Manual