Product manual

Series B900-N and B900SW-N Manifold Mounted Electric Guns
39
E 2006 Nordson Corporation
Part 1041221B
12. If the knockout hole was used to remove the old RTD, seal it with a silicone sealant (P/N
900411).
13. Route the RTD wires through the armored conduit and back shell. Push the gold pins
into positions 4 and 5 on the back shell. Pull the pins into their final positions such that
they click into place.
14. Reassemble the conduit and tighten the set screws. On water-resistant guns, seal the
set screws with a silicone sealant (P/N 1019259).
15. Inspect the gasket and replace if damaged.
16. Install the gasket and manifold cover.