Product manual

Series B900-N and B900SW-N Manifold Mounted Electric Guns
4
Part 1041221B
E 2006 Nordson Corporation
Installation Practices (contd)
S Properly ground all equipment. Contact your local building code enforcement agency for
specific requirements.
S Ensure that fuses of the correct type and rating are installed in fused equipment.
S Contact the authority having jurisdiction to determine the requirement for installation
permits or inspections.
Operating Practices
S Familiarize yourself with the location and operation of all safety devices and indicators.
S Confirm that the equipment, including all safety devices (guards, interlocks, etc.), is in
good working order and that the required environmental conditions exist.
S Use the personal protective equipment (PPE) specified for each task. Refer to Equipment
Safety Information or the material manufacturer’s instructions and MSDS for PPE
requirements.
S Do not use equipment that is malfunctioning or shows signs of a potential malfunction.
Maintenance and Repair Practices
S Perform scheduled maintenance activities at the intervals described in this document.
S Relieve system hydraulic and pneumatic pressure before servicing the equipment.
S De-energize the equipment and all auxiliary devices before servicing the equipment.
S Use only new factory-authorized refurbished or replacement parts.
S Read and comply with the manufacturer’s instructions and the MSDS supplied with
equipment cleaning compounds.
NOTE: MSDSs for cleaning compounds that are sold by Nordson are available at
www.nordson.com or by calling your Nordson representative.
S Confirm the correct operation of all safety devices before placing the equipment back into
operation.
S Dispose of waste cleaning compounds and residual process materials according to
governing regulations. Refer to the applicable MSDS or contact the authority having
jurisdiction for information.
S Keep equipment safety warning labels clean. Replace worn or damaged labels.
Equipment Safety Information
This equipment safety information is applicable to the following types of Nordson
equipment:
S hot melt and cold adhesive application equipment and all related accessories
S pattern controllers, timers, detection and verification systems, and all other optional
process control devices