Operation Manual
Table Of Contents
- Introduction
- Controls and Functions
- D1500 Quick Start
- Using the D1500 as an RTA.
- GLOBAL
- Selecting the Input
- Using the Microphone Input
- Operating the D1500
- MIDI and D Net
- Using the D1500 as a Signal Generator
- Using the D1500 as a VU Meter
- Operating the PHASE meter
- Using the D1500’s EQ Display
- FREQ – FREQUENCY
- HOLD
- RES – RESOLUTION
- REF - REFERENCE LEVEL
- WEIGHT
- INTEG – INTEGRATION
- DETECT
- GAIN
- SOURCE
- Adjusting the RTA parameters
- Using the ANALYZE Mode
- Operating the D1500 with the D2500 Digital EQ
- Operating the D1500 with the D2500 Equalizer
- Operating the D1500 with an Analog 31-band Equalizer
- Grounding Techniques
- D1500 Wiring Guide
- Specifications
11
• Next, select the signal you want to generate by
pressing the SOURCE switch and selecting either
WHITE, PINK or SINE WAVE.
• If you are using a SINE Wave, you can change the
frequency by pressing the FREQ switch and using
the Data Wheel to tune in the frequency you want.
• Now, adjust the level by pressing the GAIN switch
and then using the Data Wheel to adjust the level
from -98 dB to 22 dB w
hen the Reference scale
is set to -10 dBV, from
+16 to -104
when the
Reference scale is set to +4 dBu,
and from
-120 dB
to 0 dB
when the Reference scale is set to Digital
Maximum.
Operating the D1500
Using the D1500 as a Signal Generator
Before you get started using the Generator, press and
hold the GEN switch for about two seconds and take
notice of the parameters that can be adjusted while
using the Generator. You’ll notice that the SOURCE, GAIN,
REF and FREQ are illuminated indicating that these
parameters can be edited.
The D1500 is a sophisticated, lab quality, Signal Gen-
erator capable of producing PINK or WHITE noise, as
well as a tunable Sine Wave. To access the D1500’s
Signal Generator press the GEN switch. When you
press and hold the GEN switch you will see that the
parameters SOURCE, GAIN, REF and FREQ are avail-
able for adjustment for the signal generator.
• Press the GEN switch to enable the Signal
Generator.
• Select the proper operation reference level by
pressing the REF switch and select -10 dBV, +4dBu
or Digital Maximum.