User Manual

ManualsBrandsSamson ManualsToolsDOUBLE BRAID Class II Eye Splice Modified for TS-II Turbo

PAGE 3 OF 8

SamsonRope.com | Email CustServ@SamsonRope.com | Tel +1.360.384.4669

Double Braid Class II Eye Splice Modiﬁed for TS-II Turbo

SAMSON SPLICING INSTRUCTIONS

Pull tail out of the rope to expose the

previously tapered area. Remove the d

and any tape at the end of the tail. From

the end of the tail, mark 3 consecutive

strands, as shown. Pull them out of the

braid and cut off close to the body of the

rope. Now, using both hands and the

weight of your body, smooth the cover

slack from Mark 3 towards Mark 4. The

tail will disappear into the rope, and a

smooth, gradual taper should result.

Pull out marked strands and cut off

When nished, Mark 2 and Mark 3 should

be at the same point in the vertex of the

eye—which yields eye size desired.

Measure 3-1/2 tubular d

lengths from Mark 3 on the

core and make Mark 4 on the

core. Insert d and tapered

tail at Mark 3 and bring d

out at Mark 4. You may need

to slide the cover back at

Mark 4 slightly. Pull d and

tapered tail out. Don’t let the

line twist. Use care when the

tail passes the cut end of the

Duravet core.

Mark 3

Mark 2

Mark 4

Smooth

Tapered Tail

Standing part of rope

Pull

Mark three consecutive strands

From Mark 1, in the direction of the bitter end of the line, mark every second right and left strand for 3

strands. Cut every marked strand and pull out of line (tape at end can cause resistance and may have

to be removed in order to pull out cut strands.) Tapered end will now have only 6 strands remaining.

Tape tapered tail tightly to keep from unbraiding.

Mark 3

Mark 4

Mark 2

ﬁd

Mark 1

3-1/2

ﬁd lengths

Tapered tail

Push

Toward eye, loop, and end

3 pairs of strands, right

and left, pulled out and cut off

Mark 2

Mark 1

Retape end to

stop unbraiding

MAKING TAPER

BURYING TAIL INTO STANDING PART OF LINE

FINISH BURYING TAIL

FINISHING EYE SPLICE