Owner's Manual
Table Of Contents
- Owner's Manual
- Important Safety Information
- Introduction
- Features
- XP312w Mixer Callouts
- XP312w Rear Panel Callouts
- CR88a Receiver Display
- Using the CR88a Receiver
- Using the CR88a Receiver
- CH88 Handheld Transmitter Callouts
- Quick Start
- Connecting Samson XPD Wireless
- Using the LINE OUT Jack
- Using a Speaker Stand
- Charging the Battery
- Installing the CR88a Receiver
- Specifications
- Concert 88a Operating Bands and Frequency Ranges
- Product Registration
XP312w • Portable PA System 17
ENGLISH
FRANÇAISDEUTSCHEESPAÑOLITALIANO
The XP312w comes with one CR88a
receiver installed. You can add an additional
CR88a receiver to the system. Follow these
steps to install the receiver.
1. Turn the XP312w POWER off and leave
the AC power cable disconnected until
the installation process is completed.
2. Press the button with the arrow under
the blank receiver panel until the panel
pops out (you may need to use a non-
marking tool).
3. Remove the blank panel by sliding it
out of the XP312w.
4. Align the CR88a module with the open
slot and slide the module in until it is
fully seated in the XP312w.
Note: When using multiple systems, each
system must be set to a different operating
channel.
Installing the CR88a Receiver