Datasheet

ZOOM H4
30
Stereo Mode
This section describes the stereo mode functions and operation steps.
What is stereo mode?
In stereo mode, two signals either from the built-
in stereo mic or from the [INPUT 1]/[INPUT 2]
jacks are used as recording sources to create a
stereo file. You can select either WAV or MP3 as
format for the recorded file, and you can change
the sampling rate and bit rate as required.
NOTE
• In stereo mode, only stereo recording and
playback are possible. Multi-track recording is
not supported.
• In stereo mode, recording will always start out
with a new file, at the beginning of the file. It is
not possible to use and overwrite an existing
file.
The stereo mode top screen is shown below.
Switching to stereo mode
The two main operation modes of the H4 are
stereo mode and 4-track mode. When power to
the H4 is turned on, it will be in the mode that
was selected the last time the unit was used.
The currently selected mode is shown by the
[MODE] indicator on the top panel. When the
indicator is lit, the unit is in stereo mode. When
the indicator is out, the unit is in 4-track mode.
1.
Stop the recorder and press the
center of the [MENU] key.
The main menu for making various settings
appears.
NOTE
The items shown on the main menu are different
for stereo mode and 4-track mode.
2. Move the jog dial up/down to bring
the cursor to “MODE” and then press
the jog dial.
The MODE SELECT screen appears.
Counter showing the current recorder position
Phantom power supply on/off
(When set to on, the phantom
voltage +48V or +24V is shown)
Recorder
operation
status
Selected file name
A-B repeat function enable button
Recording/playback level meter
Stereo mode 4-track mode
Lit
Out
H4_E.book 30 ページ ２００６年９月１日 金曜日 午後７時５６分