Datasheet

Stereo Mode
ZOOM H4
36
Using the monitor function
To monitor the level of the input signal in stereo
mode, the recorder must be set to recording
standby mode, or the INPUT LEVEL screen for
adjusting the recording level must be brought up.
However, when the monitor function has been
set to ON in the INPUT menu, the input signal
can always be monitored.
1.
At the stereo mode top screen, press
the bottom (INPUT MENU) of the
[MENU] key.
The INPUT menu for making various input
related settings appears.
2.
Move the jog dial up/down to bring
the cursor to “MONITOR”. Then
press the jog dial.
The monitor function can now be switched on or
off.
3.
Move the jog dial up/down to select
“ON”. Then press the jog dial.
The monitor function is now enabled.
4.
Press the center of the [MENU] key
to return to the stereo mode top
screen.
Playback in stereo mode
This section explains the steps required for
playback of a file recorded in stereo mode.
Selecting a file for playback
In stereo mode, each recording session will
produce one stereo file (WAV or MP3). These
files are saved in a dedicated folder on the SD
card called “STEREO”. The procedure for
selecting a file from this folder for playback is
explained below.
1.
Verify that the display shows the
stereo mode top screen.
File selection is carried out at the top screen.
HINT
• When there is no file recorded in stereo mode,
the indication “NO DATA” is shown.
• Files recorded in stereo mode have the name
“STE-xxx.wav (mp3)” which is assigned
automatically. (xxx is a number from 000 to
999.)
•You can change the file name (
→ p. 72).
2.
Move the jog dial up/down to bring
the cursor to the desired file name.
Then press the jog dial.
The file name is shown in reverse, and file
selection is possible.
3.
Move the jog dial up/down to select a
Name of currently selected file
H4_E.book 36 ページ ２００６年９月１日 金曜日 午後７時５６分