Datasheet

Miscellaneous Settings
ZOOM H4
82
interface. The setting method is the same as
when making effect section settings in 4-track
mode.
• TUNER
Sets the tuner operation for the audio
interface. The setting method is the same as
when making tuner settings in 4-track mode.
• PHANTOM
Sets the phantom power supply operation for
the audio interface. The setting method is the
same as when making the normal phantom
power supply settings.
HINT
• For input/output of audio signals via the H4,
various settings will also have to be made at
the DAW software application. For details, refer
to the documentation of the software.
•Effects can only be used when the sampling
rate is 44.1 kHz.
• Make sure that the sampling rate selected at
the H4 and the sampling rate selected at the
computer are matched. Otherwise correct
communication with the computer is not
possible.
NOTE
Settings made with the procedure described here
will be effective only when using the H4 as an
audio interface and will be saved separately. They
have no effect on the settings for stereo mode
and 4-track mode operation.
7.
To terminate the connection, press
the center of the [MENU] key in step 6.
The indication “Terminate The Connection”
appears on the display. When you select the OK
button, the connection to the computer is
terminated, and the screen that was shown before
establishing the connection appears again.
If you select the CANCEL button, the message
disappears and the connection is maintained.
If power to the H4 is being supplied via the USB
link with the [POWER] switch set to off, this
operation has no effect.
8.
To return to the stereo mode or
4-track mode top screen, repeatedly
press the center of the [MENU] key.
NOTE
If power to the H4 is being supplied via the USB
link, pressing the center of the [MENU] key will not
cancel the selected USB function. To return to the
normal top screen, disconnect the USB cable to
turn power off, and then start the H4 normally by
setting the [POWER] switch to ON.
Using the H4 as an SD card reader
The USB connection can also be used to access
an SD card inserted in the H4 from the computer.
This is convenient to transfer material recorded
with the H4 to the computer, for further editing
or mixing.
1.
Connect the [USB] port of the H4 to
the computer, using a USB cable.
2.
Verify that the recorder is stopped.
Then press the center of the [MENU]
key at the stereo mode or 4-track
mode top screen.
The main menu for miscellaneous settings of the
H4 appears.
3.
Move the jog dial up/down to bring
the cursor to “USB”, and then press
the jog dial.
The USB MODE SELECT screen appears.
H4_E.book 82 ページ ２００６年９月１日 金曜日 午後７時５６分