RSX PASSIVE LOUDSPEAKERS RSX115 RSX215 OWNER'S MANUAL
Safety Instructions WARNING: To reduce the risk of fire or electric shock, do not expose this unit to rain or moisture. To reduce the hazard of electrical shock, do not remove cover or back. No user serviceable parts inside. Please refer all servicing to qualified personnel.
Table of Contents Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Key Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Input Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Basic Set Up . . . . . . . . . . . . .
Introduction Thank you for purchasing the Samson RSX series passive loudspeaker system. The RSX series are high performance, two-way passive loudspeakers designed for portable, front of house and fixed installation sound reinforcement applications. Perfect for large PA systems, the RSX215 features two, heavy-duty 15" (380 mm) low frequency drivers with 3" (76 mm) voice coils, with power handling of 1200 watts AES, and 4800 watts peak.
Key Features The RSX series two-way loudspeaker systems are perfectly suited for portable and permanent sound reinforcement applications. Here are some of their main features: RSX115 • Two-way passive loudspeaker system • High power handling: 600 watts AES / 2400 watts peak • 15" (380 mm) low-frequency driver with 3" (76 mm) voice coil for extended low frequency response • Celestion CDX1-1745 1.
Input Connections The RSX has a pair ¼" (TS) phone and Speakon® connectors wired in parallel. This enables you to directly connect an extension cabinet to an RSX speaker. Only use one ¼" or Speakon® connector as an input connector from an amplifier. Typically, you will only connect a single extension cabinet to an RSX cabinet, but it is possible to daisy-chain multiple cabinets.
Basic Set Up The RSX loudspeakers are passive cabinets, which means that they need to be connected to a power amplifier to reproduce an audio signal. Each speaker cabinet features two sets of parallel connectors. This enables each cabinet to be daisy chained to an additional loudspeaker. When connecting multiple speaker to a power amplifier or powered mixer, you must pay attention to the minimum load impedance of the amplifier.
Using Speaker Stands - RSX115 The RSX115 features a standard 13∕8" pole mount receptacle, which enables the speaker to be mounted on a standard tripod stand or subwoofer satellite pole. For best results raise the speakers above the heads of the listening audience. When mounting a speaker onto any stand, always ensure that the stand is on a flat, level surface, with the legs fully extended. Be sure to check that the maximum load weight for the stands is greater than the weight of the RSX115.
Permanent Installation The RSX series loudspeakers are a perfect solution for many fixed installations such as live sound venues, discos, schools, houses of worship, convention centers and airport terminals. The enclosure is extremely versatile for installation as it can be suspended in several different positions by using the twelve fly points. IMPORTANT NOTE: Suspending an RSX loudspeaker should only be done by a qualified, licensed and insured professional sound contractor.
Cable Wiring The RSX series speaker connections are made via the rear panel 1/4-inch and/or Speakon® connectors for easy interface with industry standard cables. Standard, unshielded speaker wire, available at your local pro audio or music store, with either 1/4-inch phone or Speakon® connectors and wire gauge of 12-14 awg is recommended.
Technical Specifications: Model Power Rating Nominal Impedance Frequency Response Sensitivity (1w @ 1m) Maximum SPL LF Driver HF Driver HF Protection Directivity Enclosure Finish Suspension Transportation Grille Connectors Dimensions (H x W x D) Net Weight Shipping Weight RSX115 RSX215 600 watts AES 1200 watts AES 2400 watts peak 4800 watts peak 8 ohms 8 ohms 50 Hz to 20 kHz ±3dB 40 Hz to 20 kHz ±3dB 98 dB 98 dB 127 dB SPL 132 dB SPL 1 x 15" mm (380 mm) woofer 2 x 15" (380 mm) woofer with with 3" mm (76 m
Dimensions 386.7 386.7mm mm (15.2”) (15.2”) 192.4 192.4mm mm (7.5”) (7.5”) 442.3 442.3mm mm (17.4”) (17.4”) RSX115 310.3 mm (12.2”) 386.7 mm (15.2”) 334 334mm mm (13”) (13”) 588 588mm mm (40”) (40”) 720 720mm mm (28.3”) (28.3”) 192.4 mm (7.5”) 442.3 mm (17.4”) 310.3 310.3mm mm Top View (12.2”) Front View (12.2”) Side View 334 mm (13”) 386.7 386.7mm mm (15.2”) (15.2”) 720 mm (28.3”) 588 mm (40”) 442.3 442.3mm mm (17.4”) (17.4”) RSX215 310.3 mm (12.2”) 386.7 mm (15.2”) 523.5 523.
Samson Technologies Corp. 45 Gilpin Avenue Hauppauge, New York 11788-8816 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 631-784-2201 www.samsontech.
