S Class Signal Processors Line Level Converter Box
Table Of Contents Introduction and Features Front and Rear Panel Layout 3 4 Operating the S convert Using the LEVEL controls Typical Set-up 5 6 Wiring Guide Specifications 7 8 Copyright 2003, Samson Technologies Corp. Printed January 2003 Samson Technologies Corp. 575 Underhill Blvd. P.O. Box 9031 Syosset, NY 11791-9031 Phone: 1-800-3-SAMSON (1-800-372-6766) Fax: 516-364-3888 www.samsontech.
S convert Introduction and Features Introduction Thank you for purchasing the S convert stereo line level converter from Samson Audio! S convert provides a convenient solution for matching levels and interfacing audio devices, either on stage or in the studio.
S convert Front and Rear Panel Layout Front Panel Layout 1 +4 LEVEL - Control knob used to adjust the signal level connected to the +4dBu, XLR inputs. 2 +4 LEFT INPUT- XLR balanced input for connecting left, +4dBu input signals. 3 +4 RIGHT INPUT- XLR balanced input for connecting right, +4 dBu input signals. 4 -10 OUTPUT RIGHT- RCA connector outputs the right side -10 dBV signal. 5 -10 OUTPUT LEFT- RCA connector outputs the left side -10 dBV signal.
Operating the S convert The basic procedure for setting up and using your S convert is simple and takes only a few minutes. Remove all packing materials (save them in case of need for future service) and check to make sure that you remove the supplied AC power adapter. • Connect the output from the device you want to level match (like a consumer CD player using standard RCA cables) to the S converts –10dBV, Left & Right RCA inputs.
Operating the S convert Typical Set-up The diagram below shows a typical set-up for a project recording studio using the S convert to match the levels of a consumer CD player to the correct operating level of a professional DAT recorder.
S convert Wiring Guide Wiring Guide There are several ways to interface the S convert, depending on your exact set-up. Follow the cable diagrams below for connecting your gear.
S convert Specifications Frequency Response Noise Level Maximum Ouput Level Max Input Level Input Impedance Output Impedance Maximum Gain THD Noise Floor Power Dimensions Weight 10 Hz to 100kHz -110 dBu Bal: +18 dBu Unbal: +16 dBV Bal: +22 dBu Unbal: 20 dBV RCA: 100k Ohm XLR: 10k Ohm RCA: 100 Ohm XLR: 100 Ohm balanced +4 dBu In: -6 dB -10 dBV In; +19 dB .003% Max <-90 dBu 18 VDC adapter 5.65” L x 4.13” W x 2” H (144mm L x 105mm W x 51mm H) 16.5 oz., 419 gm. Samson Technologies Corp. 575 Underhill Blvd. P.
