User Manual

The Go Mic is a great microphone choice for many instrument miking situations. Below is a

brief guide on using the Go Mic in some typical applications:

Vocals

Position the microphone directly in front of the artist so that the microphone grill is

approximately 4 to 18 inches away. When close miking vocals, use of an external pop filter

like the Samson PS01 is strongly recommended. You can use the Cardioid pattern to record a

group of vocalists by positioning them around the front of the microphone. Just remember

that the extreme sides of the microphone pick up less with less high frequency response, so

have them stand together tight, and/or move the microphone from one to two feet away

from the group to pick up more room sound. You can also set the pattern to Omni mode

and have a group of vocalist in a circle around the microphone.

Acoustic Guitar

There are a variety of ways that the Go Mic can be used to mic an acoustic guitar. The

microphone placement will depend on the type of instrument and what kind of sound

you’re looking to capture, for example the tonal quality you want to focus on, and how much

finger slide or pick noise you may or may not want. When miking a standard steel string

acoustic, a good place to start is with the microphone positioned and pointing towards the

end of the fingerboard at a distance of about 6 inches to 2 feet away from the instrument.

You can experiment by moving the microphone slightly in the direction of the sound hole,

which will produce more low frequencies, or move it in the direction of the fingerboard to

capture more high-end or to remove any unwanted boominess. For nylon string acoustic,

try positioning the microphone above the bridge to emphasize more of the attack from the

sound of the finger picking, or for less, move the mic closer to the sound hole. If you have a

pair of Go Mics, try one positioned at the fingerboard and the second over the sound hole.

Application Notes