Reference Monitor System Resolv 40a Owner's manual
Connecting to t
he Resolv120a Subwoofer
Resolv 40a with Mono Sub
Adding a subwoofer and extended low frequency response to your Resolv 40a system is easy using the Resolv 40a’s LINE
LEVEL inputs. Below is a typical system set-up using the RESOLV 120a with a mixer and a pair of Resolv 40a’s satellite
speakers. The Resolv 40a’s inputs utilize industry standard RCA connectors. For a detailed wiring diagram, see the section
“Resolv 40a Connections” on page 12. Follow the steps in the diagram below to set up your system.
• Lower your mixer’s master outputs to all the way off.
• Connect the mixer’s left output to the RESOLV 120’s LEFT LINE INPUT and the mixer’s right output to the RESOLV
120’s RIGHT LINE INPUT. Now connect the RESOLV 120’s LEFT LINE OUTPUT to the left input of the Resolv 40a,
and the RESOLV 120’s RIGHT LINE OUTPUT to the right input of the Resolv 40a.
• Run an audio signal (like some music from a CD) through your mixer and raise the level to a comfortable
listening level.
• Now adjust the SWEEP control to the desired frequency. Consult your studio monitors owner’s manual for a
recommended crossover point. You can also use your ears by adjusting the SWEEP control to the frequency that
sounds good to you. A good place to start is about 70 Hz.
ENGLISH
10