User Manual

-5--8-
Clean and sanitize the Wheatgrass Juicer as indicated in the “Cleaning Instructions”
section of this manual before using it for the rst time.
DO NOT IMMERSE THE JUICER MOTOR IN WATER OR OTHER LIQUIDS.
PRIOR TO USE
DISASSEMBLY INSTRUCTIONS
1. Turn the Wheatgrass Juicer to the “OFF” Position. Disconnect the Power Cord on the
Juicer Motor from the electric outlet.
2. Loosen the Head Aligning Cap (on the Head) by turning it clockwise. DO NOT REMOVE
the Head Aligning Cap at this time. Use the Head Aligning Cap Wrench if necessary.
3. Loosen the Head Locking Screw on the Juicer Motor until it releases the Head Assembly.
4. Remove the Head Assembly from the Juicer Motor.
5. Unscrew the Head Aligning Cap from the Head by turning it clockwise.
6. Unscrew the Waste Valve from the Head Aligning Cap by turning it clockwise.
7. Remove the Rubber Gasket from the Head Aligning Cap.
8. Remove the Auger and Screen from the Head.
9. Allow the parts to air-dry before reassembling and storing the Wheatgrass Juicer.
10. The Wheatgrass Juicer is NOT dishwasher safe.
WARNING! Before cleaning, assembling or disassembling the
Wheatgrass Juicer, make sure it is turned “OFF” and the Power Cord is
disconnected from the electrical outlet.
CLEANING INSTRUCTIONS
JUICER MOTOR
1. Make sure the Power Cord on the Juicer Motor is disconnected from the electric outlet.
2. Clean the Juicer Motor by wiping it with a damp cloth. NEVER immerse the
Juicer Motor in water or other liquid. DO NOT spray the Juicer Motor with water.
3. Dry the Juicer Motor before storing it.
HEAD ASSEMBLY, STOMPER & HEAD ALIGNING CAP WRENCH
1. Fill a sink with hot water. Maintain a water temperature of at least 140
o
F (60
o
C) throughout
the washing process.
2. Add a manual dishwashing detergent formulated for commercial use to the water per the
manufacturer’s instructions.
3. Place all parts to be washed in a sink.
4. Thoroughly wash all parts with a sponge or dishcloth. Be sure to fully remove any food
residue from each part.
WARNING! Before cleaning, assembling or disassembling the
Wheatgrass Juicer, make sure it is turned “OFF” and the Power Cord is
disconnected from the electrical outlet.
OPERATING INSTRUCTIONS
1. Place a cup under the outlet on
the bottom of the Head to collect juice.
Place a cup or container under the
Waste Valve to collect pulp (Figure 6).
2. Fill the Head with
wheatgrass.
3. Make sure the Power
Switch is in the “OFF”
position. Connect the
Power Cord on the Juicer
Motor to an electrical outlet.
4. Turn the Wheatgrass
Juicer “ON” by pushing
the Power Switch to the
“Forward” position.
5. Use the Stomper to push
wheatgrass into the Head. DO
NOT use your ngers to push
wheatgrass into the Head!
6. Add wheatgrass to the Head as
needed to keep juice owing. Always
be careful. Keep your ngers clear
of the Head Opening.
7. Turn the Wheatgrass Juicer
“OFF” and disconnect the Power
Cord from the electrical outlet when
you are done.
NEVER operate Wheatgrass Juicer unless it is
fully and properly assembled.
To avoid serious or fatal injury, NEVER reach into any inlet or outlet.
ONLY USE the Stomper to push wheatgrass into the Head.
Read and understand all information in this manual before use.
WARNING!
WARNING! Before cleaning, assembling or disassembling the
Wheatgrass Juicer, make sure it is turned “OFF” and the Power Cord is
disconnected from the electrical outlet.
Figure 6
Head
Opening
KEEP FINGERS
CLEAR!
Waste
Valve
Juice
Outlet
Power
Switch