Owner's Manual

AirLine 88 Headset Wireless System 5
ENGLISHFRANÇAISDEUTSCHEESPAÑOLITALIANO
In order for your wireless system to work correctly, both the receiver and transmitter must be set
to the same channel. Follow this basic procedure for setting up and using your AirLine 88
Headset wireless system:
Physically place the CR88 receiver where it will be used, and extend the antennas
vertically. The general rule of thumb is to maintain “line of sight” between the
receiver and transmitter so that the person using or wearing the transmitter can see
the receiver.
With the CR88 powered off, connect the included power adapter. Turn the CR88 on
momentarily to confirm that the unit is receiving power. You’ll see the LED display
light up. Then turn the CR88
power off.
With your amplifier or mixer
off and volume control all the
way down, connect the CR88
receiver output jack to the mic
or line level input of a mixer or
amplifier using the balanced
XLR output or unbalanced
¼” line level output. Turn
the Level knob on the CR88
completely counterclockwise,
then turn its power on.
Quick Start
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
Make sure the AH8 Headset transmitter
is fully charged (see section Charging the
AH8 Transmitter) Turn on the power to the
transmitter by pressing and holding the
Power button for 3 seconds; the indicator
LED will light yellow when the button is
pressed and turns green when released
and the AH8 is powered on.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any
interference received, including
interference that may cause
undesired operation.
FREQ:
542-566MHz
3. Plug in receiver 4. Turn on receiver
5. Plug receiver into audio system 6. Press Select button to change channel 9. Press and hold SELECT button to IR set 10. Adjust Volume control7. Install batteries 8. Press button on transmitter to turn on
9. Press and hold Select button to IR set7. Install batteries 8. Turn on belt pack transmitter
Press the SELECT button on the front of
the CR88 receiver to choose an available
channel. The channel number will
increase by one digit, from 0-9 then A-F.
Once the last channel has been reached,
the count will cycle back to 0.