OWNER'S MANUAL
Copyright 2019, Samson Technologies Corp. v3 This product is covered by the US patent: US9,602,053 and D843,347 Samson Technologies Corp. 278-B Duffy Ave Hicksville, NY 11801 www.samsontech.
Important Safety Information ATTENTION RISQUE D’ÉLECTROCUTION ! NE PAS OUVRIR ! CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
Important Safety Information 13. Unplug the apparatus during lightening storms, or when unused for long periods of time. 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 14. Refer all servicing to qualified personnel.
Important Safety Information FCC Rules and Regulations Samson wireless receivers are certified under FCC Rules part 15 and transmitters are certified under FCC Rules part 74. Licensing of Samson equipment is the user’s responsibility and licensability depends on the user’s classification, application and frequency selected. This device complies with Part 15 of the FCC rules Class B and RSS-210 of Industry & Science Canada.
Introduction Congratulations on purchasing the Samson AirLine 88x AH8 Fitness Headset system. The AirLine 88x offers true wireless freedom without the hassle of a beltpack or cable. Featuring a lightweight, water-resistant micro transmitter headset with a secure yet comfortable fit, the system provides professional sound, premium reliability and a 300’ operating range for fitness instructors and active performers.
Quick Start In order for your wireless system to work correctly, both the receiver and transmitter must be set to the same channel. Follow this basic procedure for setting up and using your AirLine 88x Headset wireless system: Physically place the CR88x receiver where it will be used, and extend the antennas vertically. The general rule of thumb is to maintain “line of sight” between the receiver and transmitter so that the person using or wearing the transmitter can see the receiver.
Quick Start Position the AH8 transmitter about 3–12” (8–30 cm) from the front of the CR88x with the transmitter’s IR window facing the IR transmitter on the front panel of the CR88x receiver. 5. Plug receiver into audio system 6. Press Select button to change Note: The AH8 will only accept infrared transmission from the receiver for the first 10 seconds after the AH8 is powered on.
Quick Start It is recommended to use one of the included foam or stainless steel windscreens when using the AH8 headset. This will help reduce breath or wind noise. To attach the stainless steel windscreen, line up the windscreen with the end of the microphone capsule and push straight on until it is securely affixed. If you hear distortion at the desired volume level, check to see whether the PEAK Indicator LED on the receiver is lighting RED.
Charging the AH8 Transmitter 1. Snap in place the appropriate mains connector plug into the adapter. 2. Insert the magnetic power cable to the included USB AC plug (or any 5-volt DC adapter that has a USB port). Insert the AC plug into an electrical outlet. 3. Place the AH8 transmitter on a flat surface. 4. Attach the magnetic connector to the gold contact power port on the bottom of the AH8 transmitter. The cable attaches to the port magnetically.
Wearing the AH8 Transmitter The AH8 can be re-sized to fit comfortably on your head. The correct way to wear your AH8 Headset transmitter is over the ears, as you would wear a pair of eyeglasses. Because the AH8 Headset is specially designed to be used up close, be sure to position the microphone near the corner of your lips. To avoid feedback problems, take care not to cover the mic capsule with your hand. Position the AH8 over your head so that the body of the transmitter is behind your head.
AH8 Headset Transmitter Callouts 1 4 3 5 2 6 1. Power/Mute Button - Press and hold for 3 seconds to turn the unit on or off. A quick press and release will mute or unmute the transmitter when the transmitter is on. 2. Status Indicator - This LED displays the operation mode, low battery and recharge status of the transmitter. The chart defines the LED colors for each function. GREEN Normal Operation AMBER Mute Flashing RED RED Low Battery Charging Fully Charged 3.
CR88x Receiver Features - Front Panel 1. Antennas - The antenna mountings allow full rotation for optimum placement. In normal operation, both antennas should be placed in a vertical position. Both antennas can be folded inward for convenience when transporting the CR88x. 2. VOLUME Control - This knob sets the level of the audio signal being output through both the balanced and unbalanced output jacks on the rear panel.
CR88x Receiver Features - Rear Panel 1. DC Input - Connect the supplied power adapter here, using the strain relief as shown in the illustration below. WARNING: Do not substitute any other kind of power adapter. Doing so can cause severe damage to the CR88x and will void your warranty. 2. BALANCED OUTPUT - Use this electronically balanced low impedance (600 Ohm) XLR jack when connecting the CR88x to professional (+4dBu) audio equipment.
Rack Mounting The CR88x receiver can be installed into a standard 19” rack for transport or permanent installation using the included rack ears. Follow the simple steps below to mount the CR88x: Attach the included rack ears by sliding each rack ear into the groove on either side of the CR88x until they lock into place, and the receiver flush with the front panel.
Troubleshooting Issue Solutions Make sure that the transmitter and receiver are both powered on. Ensure the AH8 transmitter’s batteries are fully charged. Check that the transmitter is not muted. Confirm that the CR88x adapter is correctly connected and plugged into an electrical outlet. Turn on the CR88x receiver. No Audio Make sure the CR88x audio output connections are securely connected. Ensure that the receiver and transmitter are in line of sight with one another.
Specifications System Working Range Audio Frequency Response T.H.D. (Overall) Dynamic Range Signal to Noise Operating Temperature Tone Key Frequency 300' (100m) line of sight 50 Hz - 15 kHz <1% (@AF 1 kHz, RF 46 dBu) >100 dB A-weighted >95 dB –10°C (14°F) to +60°C (+140°F) 35 kHz AH8 Headset Microphone Transmitter Microphone Element Condenser Mic Microphone Polar Pattern Unidirectional Input Gain Range 20dB RF Power 10mW EIRP Power Requirements 3.
Operating Bands and Frequency Ranges Band Frequency Range Kª 470–494 MHz Dª 542–566 MHz IL* 794–806 MHz B* 806–810 MHz G* 863–865 MHz * Not for use in the USA and Canada. European Frequency Operation Note: This equipment is intended for professional musical and similar applications, and may be capable of operating on some frequencies not authorized in your region.
Having Trouble with your AirLine Wireless System? We can help! CONTACT OUR SUPPORT TEAM: support@samsontech.com Our experts can help you resolve any issues. Follow us: @samson Samson Technologies 278-B Duffy Ave Hicksville, NY 11801 Phone: 1-800-3-SAMSON www.samsontech.
• • 1r~1ne Headset Wireless System
'AH8 HEADSET SAIIIISON. How to adjust the AH8 headband: Snap the strap onto the headset. The snaps are labeled L & R. The Left side is the microphone boom side. The snaps have three positions: front, middle and back. The strap can be pulled in or out to be made longer or shorter. Applying the DeoxlT solution: (Use only if the charging connector becomes visually corroded) Using the application tube, squeeze a small amount of DeoxlT onto the charging connector (it should flow over the connector).
IF PURCHASED OUTSIDE THE U.S. please visit our website www.samsontech.com/wheretobuy/international/ Select your country of purchase to contact an authorized Samson distributor for registration information.
ONLINE PRODUCT REGISTRATION Congratulations on the purchase of your new Samson product! Thank you for choosing Samson. We recommend you register your product at the web address below. Your registration is important to us and will allow you to get the latest updates from Samson. REGISTER ONLINE www.samsontech.