STAGE 212 Frequency-Agile, Dual-Channel Wireless System OWNER'S MANUAL
Important Safety Information ATTENTION RISQUE DE CHOC ~LECTRONIQUE NE PAS OUVRIR A This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock.
Important Safety Information FCC Rules and Regulations Samson wireless receivers are certified under FCC Rules part 15 and transmitters are certified under FCC Rules part 74. Licensing of Samson equipment is the user's responsibility and licensabil ity depends on the user's classification, application and frequency selected. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Important Safety Information 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with dry cloth. 7. Do not block any ventilation openings. Install in accordance with the manufacturer's instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
Introduction Congratulations on purchasing the Samson Stage 212 Dual Microphone Wireless System! The Stage 212 system is the perfect solution for any application requiring two high qual ity, wireless microphones in an easy to use package. Featuring simple operation , with 12 available channels and infrared set for the transmitter channel, the Stage 212 can quickly be up and running out of the box. The system includes the SR212 dual channel receiver with individual and mixed outputs.
SR212 Receiver Front Panel Features 1. Power Switch - Press to turn the receiver on or off. 2. IR Transmitter - During "IR SET" an infrared light is used to set the transmitter channel. 3. Channel A SELECT Button - Press this button to cyc le through Channel A receiver's operating channels. Press and hold this button to send the channel information to the transmitter via infrared transmission . 4. LED Display - The ?-segment LED display shows each receiver's current operating channel.
SR212 Receiver Rear Panel Features 1-------------~EB~-------, 2 SIN 3 14. Antenna - The antenna mountings allow full rotation for optimum placement. In normal operation, both antennas should be placed in a vertical position. The antennas can be folded down for convenience when transporting the SR212. 15. DC Input - Connect the supplied 15-volt adapter here. WARNING: Do not substitute any other kind of power adapter. Doing so can cause damage to the SR212 and will void your warranty. 16.
VH 12 Transmitter Controls and Features 1. Status Indicator - This LED displays the operation mode: 2. GREEN Normal Operation RED Mute Flashing GREEN Low Battery Power/Mute Switch - Press and hold to turn the unit on or off. Press and release to mute or unmute the transmitter. 3. SAMSON SAMSON VH12 VH12 0 0 0 Battery Cover - Unscrew the battery cover and slide down to open the VH 12 battery compartment. 4.
Quick Start In order for your wireless system to work correctly, both the receiver and transmitter must be set to the same channel. Follow this basic procedure for setting up and using your Stage 212 wireless system: Physically place the SR212 receiver where it will be used, and fully extend the antennas vertica lly. The general ru le of thumb is to maintain "line of sight" between the receiver and transmitter so that the person using or wearing the transmitter ca n see the receiver.
Quick Start With the transmitter powered off, install two fresh AA batteries into VH12 handheld transmitter. Leave the battery compartment open. Turn on the power to the transmitter by pressing and holding Power switch; the ind icator LED will light green. - """ Press the CH A SELECT button on the front of the SR212 to choose an available channel for the CH A receiver. The channel number will increase by one digit, from 1-9 then A-C. Once the last channel has been reached, the count will cycle back to 1.
Quick Start Position the VH12 transmitter about 6-12" {15-30 cm) from the front of the SR212 receiver with the transmitter's IR window facing the IR transmitter on the front panel of the SR212 receiver. Press and hold the SR212 CH A SELECT button to set the transmitter to the same channel as the receiver via infrared transmission When the transmission is complete, the SR212 wi l l receive RF signal and the tone key from the transmitter.
Specifications System Specifications Operating Frequency Number of Channels Frequency Stability Modulation Mode Maximum Deviation Operating Range Operating Temperature Range Working Humid ity Frequency Response Tone Key Frequency VHF 173MHz to 199MHz 12 channe ls ±0.005% FM ±30 kHz 50 meter 40° to 43° 65±20%RH 80 Hz to l 5kHz 30 .
Troubleshooting Issue Solutions Turn on the VH12 transmitter using the Power/ Mutr switch. Ensure the VH12 transmitter's batteries are installed correctly. Confirm that the SR212 adaptor is correctly connected and plugged into an electrical outlet. No Audio Turn on the SR212 receiver. Make sure the SR212 output and audio input connections are securely connected. Ensure that the SR212 receiver and VH 12 transmitters are in line of sight with one another.
Copyright 2017, Samson Technologies Corp. v2 Samson Technologies Corp. 278-8 Duffy Ave Hicksville, NY 11801 www.samsontech .
Samson Technologies 278-8 Duffy Ave Hicksville, NY 11801 Phone: 1-800-3 -SAMSON www.samsontech.
.4 D • ONLINE PRODUCT REGISTRATION Congratulations on the purchase of your new Samson product! Thank you for choosing Samson. We recommend you register your product at the web address below. Your registration is important to us and will allow you to get the lat.est updat.es from Samson. REGISTER ONLINE www.samsontech.
• ~ IF PURCHASED OUTSIDE THE - - ---· - - - ··- ·- -- - - - - - - --- - -- -- --- ---- - - -------- U.S. --- --- - - --- ·- please visit our website www.samsontech.com/ wheretobuy/ international/ Select your country of purchase to contact an authorized Samson distributor for registration information.
