Specifications

Guided Tour - AP1 Receiver
6
9: Output jack - Use this standard unbalanced high
impedance (5 - 10 K Ohm) 1/4" jack to connect the AP1 to
your amplifier or audio mixer. Wiring is as follows: tip hot,
sleeve ground.
10: DC input - Connect an optional 12 volt 200 mA power
adapter (available from your Samson dealer) here.
WARNING: Do not substitute any other kind of power
adapter; doing so can cause severe damage to the AP1 and
will void your warranty. Note that the AP1 can also be
battery powered (see #7 on the previous page and the
“Setting Up and Using Your AirLine System” section on page
15 in this manual).
11: Squelch control - This control determines the maximum
range of the AP1 before audio signal dropout. Although it
can be adjusted using the supplied plastic screwdriver, it
should normally be left at its factory setting. See the “Setting
Up and Using Your AirLine System” section on page 15 in this
manual for more information.
ENGLISH
DC INPUT
12 VDC
SQUELCH
MIN MAX
10
11
OUTPUT
9
Samson AirLine