User's Manual

3. MagicLAN Installation For

Windows 98SE/ME/2000/XP

We will explain the installation method for SWL-2300M/N/P (MiniPCI/PCMCIA/PCI Card) .

3.1 Installation Overview

Here are some steps you will perform in establishing your wireless network connection:

1. Install the Access Point at first. AP is needed in case of Infrastructure network mode.

2. You should install the Wireless LAN Card (SWL-2300M/N/P).

3. Install the software using the Installation CD.

4. Install the network protocol(s) required to communicate on your network. Most likely

you will need the TCP/IP protocol.

3.2 Installation Procedure of Windows 98SE

Please follow the following steps one by one to install the MiniPCI/PCMCIA/PCI card

successfully.

< Method 1 - Inserting card first >

1. Insert the MiniPCI/PCMCIA/PCI Card into the slot of your computer.

2. Power on your computer and allow Windows 98SE to load fully.

3. “Add New Hardware Wizard” appeared and the system looks for “PCI Network

Controller”. Press ‘NEXT’ button and check if “Search for the best driver for your

device(recommended)” is selected and then press ‘NEXT’ button . Insert the MagicLAN

Installation CD into the CD-ROM drive.

4. Mark the “Specify a location” tap and type “E:\Drivers” right below in this tap(Where

E is the CD-drive of your PC) and then press ‘NEXT’.