User's Manual

Basic Recording
✤ The EASY Q mode works only in Camera mode.
✤ The EASY Q mode allows a beginner to easily make good recordings.
1. Set the Power switch to CAMERA.
2. Set the Mode switch to TAPE. (SCD353/D354/D355 only)
3. By pressing the EASY Q button, all functions on the camera will be set to off and the recording
settings will be set to the following basic modes:
■
Battery level, recording mode, counter, date/time, and DIS ( ) will be displayed.
■
The word EASY Q will appear on the LCD screen at the same time.
However, the Date/Time will only be seen if it has been previously set. (see page 33)
4. Press the Start/Stop button to start recording.
Recording will begin using the basic automatic settings.
5. Press the EASY Q button again in the STBY mode and then turn the EASY Q mode off.
■
The EASY Q function will not turn off while you are recording.
■
The camera will return to the settings that were set prior to activating EASY Q mode.
[ Notes ]
■
In EASY Q mode, certain functions are not available, such as Menu, BLC, AF/MF.
If you want to use these functions, you must first switch the EASY Q mode off.
■
The EASY Q mode settings are deleted when the Battery pack is uninstalled from the Camcorder and
therefore, they must be reset when a Battery pack has been replaced.
■
EASY Q mode will not turn off during a recording.
Using EASY Q Mode (for Beginners)
14min
0:00:10
12:00 AM JAN.01,2005
SP
STBY
4040
ENGLISH
3
1
Dragon_eng_26~85 12/13/04 3:25 PM Page 40