User's Manual

fundamental and out of band emissions). The host manufacturer must verify that there are no
additional unintentional emissions other than what is permitted in Part 15 Subpart B or
emissions are complaint with the transmitter(s) rule(s). The Grantee will provide guidance to the
host manufacturer for Part 15 B requirements if needed.
7. End Product Labeling :
Due to the very small size of the AX211D2W, the marking has been placed in this user manual
because the product label on the devices is considered too small to be readable.
FCC ID : A3LAX211D / IC : 649E-AX211D
Host system must be labeled with "Contains FCC ID : A3LAX211D", FCC ID displayed on label.
and "Contains IC : 649E-AX211D, IC no. displayed on label.
8. Antenna Installation :
Only antennas of the same type and with equal or less gains as 3dBi for the 2.4GHz band and
5dBi for the 5GHz require additional authorization for operation. For testing purposes the
following dual band antenna that approximates closely the above limits was used:
9. Conditions To Be Observed By Use of 6 GHz Bands (5.925 GHz –
7.125 GHz)
An indoor client device (6XD), where a client device is defined in FCC Part. 15.202, is limited to
indoor locations and is under control of a low-power indoor access point (6ID) or
subordinate(6PP). It is only possible to operate the client device can only operate under the
control of a low-power indoor access point and subordinate.
A client may initiate brief messages to associate with a low-power indoor access point or
subordinate and establish a connection only after receiving a confirmation signal confirming that
an AP is present and operating on a particular channel. After being associated, the indoor client
can only initiate transmission with that access point. Indoor client devices (6XD) are prohibited
from making a direct air interface connection to other clients. An indoor client device cannot
have a direct connection to the internet.
10. Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to
install or remove this RF module in the user’s manual of the end product which integrates this
module. The end user manual shall include all required regulatory information/warning as show
in this manual.