User's Manual

6
No
Item
Pin NO
Min
Typ
Max
Unit
Comments
1
Supply Voltage
VCC
4, 5 ,72, 73
3.135
3.3
3.465
V
3-4. Antenna port
This is a description of the signal line of the antenna interface of this product.
Pin number
Name
Functionality
Chain A
ANT 1
SISO1
Aux
Wifi+Bluetooth
Chain B
ANT 2
(ANT 3)
SISO2
Main
Wifi Only
4. Safety precautions :
This module should be used at authorized places or environments due to frequency
jamming possibility while operating. If occur any issues when the module operates at not
authorized places or environments, Samsung Electronics does not have any
responsibility.
5. FCC Part 15 Information and Notices
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter.
6. Important Notice to integrators