User's Manual

7
1. This module is limited to OEM installation ONLY.
2. This module is limited to installation in mobile or fixed applications, according to Part 2.1091(b).
3. The separate approval is required for all other operating configurations, including portable configurations with
respect to Part 2.1093 and different antenna configurations
4. For FCC Part 15.31 (h) and (k): The host manufacturer is responsible for additional testing to verify compliance
as a composite system. When testing the host device for compliance with Part15 Subpart B, the host
manufacturer is required to show compliance with Part 15 Subpart B while the transmitter module(s) are
installed and operating. The modules should be transmitt and the evaluation should confirm that the
module's intentional emissions are compliant (i.e. fundamental and out of band emissions).
The host manufacturer must verify that there are no additional unintentional emissions other than what is
permitted in Part 15 Subpart B or emissions are complaint with the transmitter(s) rule(s).
The Grantee will provide guidance to the host manufacturer for Part 15 B requirements if needed.
7. End Product Labeling :
Due to the very small size of the AX211D2W, the marking has been placed in this user manual because the
product label on the devices is considered too small to be readable.
FCC ID : A3LAX211D730QED / IC : 649E-AX211730QED
Host system must be labeled with "Contains FCC ID : A3LAX211D730QED", FCC ID displayed on label.
and "Contains IC : 649E-AX211730QED, IC no. displayed on label.
8. Antenna Installation :
Only antennas of the same type and with equal or less gains as 3dBi for the 2.4GHz band and 5dBi for the
5GHz require additional authorization for operation. For testing purposes the following dual band antenna
that approximates closely the above limits was used:
9. Conditions To Be Observed By Use of 6 GHz Bands (5.925 GHz – 7.125
GHz)
An indoor client device (6XD), where a client device is defined in FCC Part. 15.202, is limited to indoor locations and
is under control of a low-power indoor access point (6ID) or subordinate(6PP). It is only possible to operate the
client device can only operate under the control of a low-power indoor access point and subordinate.
A client may initiate brief messages to associate with a low-power indoor access point or subordinate and establish
a connection only after receiving a confirmation signal confirming that an AP is present and operating on a particular
channel. After being associated, the indoor client can only initiate transmission with that access point. Indoor client
devices (6XD) are prohibited from making a direct air interface connection to other clients.
An indoor client device cannot have a direct connection to the internet.
10. Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module. The end user
manual shall include all required regulatory information/warning as show in this manual.
11. List of applicable FCC rules
This wireless adapter is restricted to indoor use due to its operation in the 5.15 to 5.25 and 5.470
to 5.75GHz frequency ranges. No configuration controls are provided for Intel® wireless adapters