User's Manual

11. List of applicable FCC rules
This wireless adapter is restricted to indoor use due to its operation in the 5.15 to 5.25 and
5.470 to 5.75GHz frequency ranges. No configuration controls are provided for Intel® wireless
adapters allowing any change in the frequency of operations outside the FCC grant of
authorization for U.S. operation according to Part 15.407 of the FCC rules.
1) wireless adapters are intended for OEM integrators only.
2) wireless adapters cannot be co-located with any other transmitter unless approved by the
FCC
12. This device is intended only for OEM
integrators under the following conditions: (For
module device use)
1) The antenna must be installed such that 20 cm is maintained between the antenna and
users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
13. RF Exposure Statement
The FCC with its action in ET Docket 96-8 has adopted a safety standard for human exposure
to radio frequency (RF)electromagnetic energy emitted by FCC certified equipment. The
wireless adapter meets the Human Exposure requirements found in FCC Part 2, 15C, 15E
along with guidance from KDB 447498, KDB 248227 and KDB 616217.
Proper operation of this radio according to the instructions found in this manual will result in
exposure
substantially below the FCC’s recommended limits.
The following safety precautions should be observed:
- Do not touch or move antenna while the unit is transmitting or receiving.
- Do not hold any component containing the radio such that the antenna is very close or
touching any exposed parts of the body, especially the face or eyes, while transmitting.
- Do not operate the radio or attempt to transmit data unless the antenna is connected; this
behavior may cause
damage to the radio.
- Use in specific environments:
- The use of wireless adapters in hazardous locations is limited by the constraints posed by the
safety
directors of such environments.
- The use of wireless adapters on airplanes is governed by the Federal Aviation Administration
(FAA).
- The use of wireless adapters in hospitals is restricted to the limits set forth by each hospital.
This module will be installed into any host and SAR re-assessment might be needed for host
product. The OEM or integrator is responsible to perform the required additional host regulatory
testing and/or obtaining the required host approvals for compliance.