User's Manual

7
7. End Product Labeling :
Due to the very small size of the AX210D2W, the marking has been placed in this user manual because the product
label on the devices is considered too small to be readable.
FCC ID : A3LAX211D950QED
8. Antenna Installation :
Only antennas of the same type and with equal or less gains as 3dBi for the 2.4GHz band and 5dBi for the
5GHz require additional authorization for operation. For testing purposes the following dual band antenna
that approximates closely the above limits was used:
9. Antenna Placement Within the Host Platform
To ensure RF exposure compliance the antenna(s) used with the Intel® wireless adapters must be installed in
notebook or tablet PC host platforms to provide a minimum separation distance from all persons, in all
operating modes and orientations of the host platform, with strict adherence to the table below. The antenna
separation distance applies to both horizontal and vertical orientation of the antenna when installed in the
host system.
10. Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user’s manual of the end product which integrates this module. The end user
manual shall include all required regulatory information/warning as show in this manual.
11. List of applicable FCC rules
This wireless adapter is restricted to indoor use due to its operation in the 5.15 to 5.25 and 5.470
to 5.75GHz frequency ranges. No configuration controls are provided for Intel® wireless adapters
allowing any change in the frequency of operations outside the FCC grant of authorization for
U.S. operation according to Part 15.407 of the FCC rules.
1) wireless adapters are intended for OEM integrators only.
2) wireless adapters cannot be co-located with any other transmitter unless approved by the FCC