User's Manual
Getting started_ 21
2.getting started
This chapter gives you step-by-step instructions for setting up the USB connected machine and software.
• Setting up the hardware
• Printing a demo page
• Supplied software
• System requirements
• Installing USB connected machine’s driver
• Sharing your machine locally
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware, as is explained in the
Quick Install Guide. Make sure you read the Quick Install Guide first and
follow the steps below:
1. Select a stab
le location.
Select a level, stable place with adequate sp
ace for air circulation. Allow
extra space to open covers and trays.
The area should be well ventilated and away from direct sunlight or
sources of heat, cold, and humidity. Do not set the machine close to the
edge of your desk or table.
Printing is suitable for altitudes under 1,000 m (3,281 ft). Refer to the
altitude setting to optimize your printing (See "Altitude adjustment" on
page 34).
Place the machine on a flat, stable surface so th
at there is no incline
greater than 2 mm (0.08 inch). Otherwise, printing quality may be
affected.
2. Unpack the machine and check all the enclosed items.
3. Remove al
l tape.
4. In
stall the toner cartridges.
5. Loa
d paper (See "Loading paper in the tray" on page 37).
6. Ma
ke sure that all cables are connected to the machine.
7. Turn
the machine on.
This equipment will be inoperable when mains power fails.
PRINTING A DEMO PAGE
Print a demo page to make sure that the machine is operating correctly.
To print a demo page:
1. Press
on the control panel.
2. Pre
ss left/right arrow until Information appears and press OK.
3. Pres
s the left/right arrow button until Demo Page appears and press
OK.
4. Pre
ss left/right arrow until Print? appears and press OK.
The machine starts to print a demo page.
SUPPLIED SOFTWARE
After you have set up your machine and connected it to your computer, you
must install the printer software. If you
are a Windows or Macintosh OS
user, install the software from the suppl
ied CD and if you are a Linux OS or
UNIX OS user, download the software fro
m the Samsung website
(www.samsung.com/printer) and install.