User's Manual

Solving Problems
7. 15
Main Motor
Error
A problem has
occurred in the
development motor of
the printer.
Unplug the power cord and
plug it in again. If the problem
persists, call for service.
Memory
Overflow
The printer does not
have enough memory
to print the current
job.
An error has occurred
in the firmware
program of the
printer.
The job automatically clears
and the printer returns to
Standby Mode.
Paper Empty
[Size] In Tray1
Paper Empty
[Size] In Tray2
Paper Empty
[Size] In Mp
Paper Empty
[Size] In Manual
The paper tray has
run out of paper.
Load paper in the paper tray.
See page 4.2.
Press
Continue Button
The printer is waiting
for the user’s action
before printing from
the Multi-purpose
Tray using the manual
feed mode.
Load a sheet of print material
and press the
On Line/
Continue
button. You need to
press the button for each page.
Ready [Color]
Low Toner
The corresponding
toner cartridge in
your printer is low on
toner.
Redistribute the toner in the
corresponding toner cartridge,
referring to page 6.2.
Ready
IP Conflict
The IP address of the
printer conflicts with
other devices on the
network.
Contact your network
administrator and choose an
address within your subnet
which will not conflict with any
other devices.
Replace [Color]
Toner
The corresponding
toner cartridge in
your printer is nearly
empty. However, the
printer continues
printing, even though
print quality is not
optimal.
If necessary, replace the
corresponding toner cartridge
with a new one. See page 6.4.
Replace Fuser The life span of the
fuser unit has
expired.
Replace the fuser unit with a
new one. See page 6.7.
Message Status Do this...
Replace Fuser
Soon
The life span of the
fuser unit will expire
soon.
When “Replace Fuser” appears
on the display, replace the
fuser unit.
Replace MP
Pick-roller
The life span of the
MP pickup roller has
expired.
Contact a service
representative.
Replace
Transfer Belt
The life span of the
paper transfer belt
has expired.
Replace the paper transfer belt
with a new one. See page 6.5.
Replace Transfer
Belt Soon
The life span of the
paper transfer belt
will expire soon.
When “Replace Transfer Belt”
appears on the display, replace
the paper transfer belt.
Replace Tray1
Pick-roller
The life span of the
Tray1 pickup roller
has expired.
Contact a service
representative.
Replace Tray2
Pick-roller
The life span of the
Tray2 pickup roller
has expired.
Contact a service
representative.
Tray2 Error The optional tray 2 is
not properly installed
or connected to the
printer.
After turn the printer off and
then back on, reinstall the
optional tray 2. If the message
persists, contact a service
representative.
Tray 2 Jam
Cover Open
The optional tray 2
jam cover is open.
Close the tray 2 cover firmly.
Message Status Do this...