Use Instructions

SAIT‐IFU‐GEMS‐HRev.1.1(2019‐11) Page45of79
6.7.2.Assistcontrolarea
6.7.2.1.Setthestandpose

Makesurethathipangleisasclosetoneutralaspossiblewiththepatient standing naturally.Ifthepatientis
walkingwiththeirbackbent,theirneutralposturewillalsobestandingwithbackbent.
Incorrectsettingofthestandposemaycauseuncomfortableassistanceordegradeclinicaleffectiveness.


Makesurethatboththeleftandrightjointangleoptionsareselectedwithinthemonitoringoptiondialog.




① Resetthehipanglesensorwhilethepatientisstandinginaneutralposturewithhipsstraightifpossible,orwith
comfortablepostureotherwise.Thiswillbeusedasthereferencepositionforcalculatingflexionandextension.
② Pressthe“SetStandPose”buttontoresetthehipangletozeroandtocalibratethereferenceposture.
③ Ifthestandposeisnotset,the“START”buttonwillnotbeactivated.
④ Makesurethatbothlefttherightjointanglesareselectedinthemonitoringoptiondialogtoseebothjoint
anglesinthegraph.
