User's Manual

English

• The RJP can be returned to the factory default settings by pressing the A/V and HDMI buttons simultaneously for 10

seconds. All LEDs blink 5 times to acknowledge that this has been ﬁnished.

• The RJP will automatically turn off any LEDs after 5 minutes to avoid unnecessary light pollution in the hotel room.

The LEDs that were turned off will turn on again if the guest touches any of the buttons and the 5 minute timer will

restart. If the guest then touches another source button, the TV will change to the selected source and the corre-

sponding LED will be lit.

• After an RJP Reset or a TV Power OFF/ON, it takes approx. 10 seconds to establish communications between the

TV and the RJP.

• The following table shows the approximate time in seconds to switch from the TV to the input source, based on the

priority.

✎ Scenario 1: When no inputs are connected.

Source To Connect

AV 2 Sec

PC 0.7 Sec

HDMI 3.9 Sec

✎ Scenario 2: When two or more inputs are connected and an Input source is disconnected and then reconnected.

Source Disconnect To Connect Total

AV 4.5 Sec 2 Sec 6.5 Sec

PC 0.7 Sec 0.7 Sec 1.4 Sec

HDMI 3.9 Sec 3.9 Sec 7.8 Sec

✎ E.g. If the RJP has all its live sources AV, PC and HDMI connected, AV is viewed as the highest priority. If the RJP

is in HDMI mode, and a guest removes and reconnects the AV, the minimum time required to switch to the AV is

6.5 seconds.

• To connect audio (Ipod or Mp3), Music mode should be ON and Jack Ident detect should be OFF.

• A/V, PC and HDMI input sources are supported.

[HC460-465-EU]Install-Guide-X0ENG.indd 15 2014-05-21  3:08:24