User's Manual

Using Print Materials
4.9
1 Load letterheads into the tray you want to use, as shown
in the figures below. Adjust the guides to fit the width of
the paper stack.
2 When you print, set the paper source, type, and size
properly in the software application. For details, see the
Software User’s Guide .
For details about setting on the control panel, see
page 3.3.
Printing on Card Stock or Custom-
sized Materials
Postcards, 3.5 by 5.83 in. (index) cards, and other custom-
sized materials can be printed with your printer. The minimum
size is 76 by 127 mm (3 by 5 in.) and the maximum size is 216
by 356 mm (8.5 by 14 in.).
1 Open the Multi-purpose Tray and pull the extender.
2 Open the rear output tray and pull the extender.
Guidelines
• Always insert the short-edge into the Multi-purpose Tray
first. If you want to print in landscape mode, make this
selection through your software. Inserting paper long-edge
first may cause a paper jam.
• Do not load more than 10 cards into the Multi-purpose Tray
at a time.
• Do not print on media smaller than 76 mm (3 in.) wide or
127 mm (5 in.) long.
• In the software application, set margins at least 6.4 mm
(0.25 in.) away from the edges of the material.
Load with the design face
down, bottom edge
towards the printer.
Load with the design
face up, top edge
towards the printer.
3 Load print material in the Multi-purpose Tray with the
print side up and short edge first
. Adjust the guide to
fit the width of the material stack.
4 When you print, set the paper source, type, and size
properly in the software application. For details, see the
Software User’s Guide .
For details about setting on the control panel, see page
page 3.3.
5 After printing, close the Multi-purpose Tray and the rear
output tray.