User's Manual

-14-
Wiring the Mains Power Supply Plug(UK Only)
IMPORTANT NOTICE
The mains lead on this equipment is supplied with a moulded plug incorporating a fuse. The value of
the fuse is indicated on the pin face of the plug and, if it requires replacing, a fuse approved to
BSI1362 of the same rating must be used.
Never use the plug with the fuse cover omitted if the cover is detachable. If a replacement fuse cover
is required, it must be of the same colour as the pin face of the plug. Replacement covers are available
from your dealer.
If the fitted plug is not suitable for the power points in your house or the cable is not long enough to
reach a power point, you should obtain a suitable safety approved extension lead or consult your
dealer for assistance. However, if there is no alternative but to cut off the plug, remove the fuse and
then safely dispose of the plug.
Do NOT connect the plug to a mains socket as there is a risk of shock hazard from the bared flexible cord.
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
BLUE - NEUTRAL BROWN - LIVE
As these colours may not correspond to the coloured markings identifying the terminals in your plug,
proceed as follows :
The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLUE
or BLACK. The wire coloured BROWN must be connected to the terminal marked with the letter L or
coloured BROWN or RED.
WARNING:
DO NOT CONNECT EITHER WIRE TO THE EARTH TERMINAL, WHICH IS MARKED WITH THE
LETTER E OR BY THE EARTH SYMBOL
, OR COLOURED GREEN OR GREEN AND YELLOW.
Russia Only - PCT Notice
TCO Recycling Information
(TCO applied model only)
For recycling information for TCO certified monitors, please contact the company corresponding to your region of
residence.
For those who reside in other countries, please contact a nearest local Samsung dealer for recycling information for
the products to be treated in environmentally acceptable way.
The information of Regional Takeback Schemes can be found at Samsung’s website
http://www.samsung.com/recycling_compliance
Risk of hazard conneting Class l Equipment to Cable Distribution Networks
For Class l equipment in Norway, intended to be connected to CABLE DISTRIBUTION SYSTEMS, the screen of a coax
cable is required to be galvanic isolated from the protective earth.
- Connection to a Cable Distribution System is to be provided through a galvanic isolator
- Må kun tilkoples kabel-TV nett via galvanisk isolator