User's Manual

User M anu a l
REV 0 .1
Samsung Electronics Proprietary and Confidential
1 6 / 2 1
2. A minimum separation distance of 20 cm must be maintained between the antenna
and the person for this appliance to satisfy the RF exposure requirements of the Council
recommendation 1999/519/EC of 12 July 1999.
As long as the 2 conditions above are met, no further evaluation under Article 3.2 of the
R&TTE Directive and do not require further involvement of an R&TTE Directive Notified
Body for the final product. In all other cases, or if the manufacturer of the final product is
in doubt then the equipment integrating the radio module must be assessed against
Article 3.2 of the R&TTE Directive.
Please note that this product, ML-NWA65L(ML-NWA65L/XRX), uses radio frequency
bands not harmonized throughout the Community. This product is classified as Class 2
radio equipment for which some Member States apply restrictions on placing on the
market and in use. Any parties putting Class 2 radio equipment on the market must
notify the relevant national spectrum management authority of their intention, and the
radio equipment must be given a Class Identifier (alert symbol).
 Antenna
This product, ML-NWA65L(ML-NWA65L/XRX), is for OEM integrations only. The end-
user product will be installed in such a manner that only the authorized antennas are
used.
 Enclosure
This product, ML-NWA65L(ML-NWA65L/XRX), is made for integrating in another final
product. For this reason, there are some parts of the final product on which the ML-
NWA65L(ML-NWA65L/XRX) depends for regulatory compliance regarding EMC and
safety. The ML-NWA65L(ML-NWA65L/XRX) is mounted on the circuit board of the final
product, and must be contained inside the case of the final product. Integrated the ML-
NWA65L(ML-NWA65L/XRX) in the final product so that its surfaces are not in contact
with the outside.
 Documentation
In the documentation for the conformity assessment of the final product, state clearly
that the ML-NWA65L(ML-NWA65L/XRX) is integrated in the system.
 Conformity Assessment of the Products integrating the ML-NWA65L(ML-
NWA65L/XRX)
The following is a supplementary explanation of conformity assessments for final
products integrating the radio modules such as the ML-NWA65L(ML-NWA65L/XRX),
that have passed conformity assessments in accordance with the R&TTE Directive. The