User's Manual

User M anu a l
REV 0 .1
Samsung Electronics Proprietary and Confidential
1 9 / 2 1
 Conformity assessment procedures for final products exempted from R&TTE
Directive Article 3.2
In every case, the manufacturer of a final product must follow the procedures for
conformity assessment of the final product with the requirements of R&TTE Directive
Article 3.1(a) and (b), for safety and EMC. The conformity assessment for Article 3.2
is carried out in accordance with the following:
1) Attach the EN 300 328 test report of the assessed radio module and the EC
Declaration of Conformity to the conformity assessment of the final product (The
Declaration of Conformity is attached to the manual).
2) Specify on the conformity assessment of the end product that the assessed radio
module was integrated in the system without any changes, in accordance with the
installation directions of the manufacturer.
 Notification of the final product
Please note that this product, ML-NWA65L(ML-NWA65L/XRX), uses radio frequency
bands not harmonized throughout the Community. The notification required by R&TTE
Directive Article 6(4) is necessary. It is the responsibility of the manufacturer of the final
product to notify the relevant national spectrum management authority of the intention to
place the final product on the market.
 CE marking
It is necessary to attach the CE mark to the final product to indicate that it conforms with
all the directives that apply to the final product. It must be given a Class Identifier (alert
symbol) in addition to the CE mark.
 Exemption clause
Samsung Electronics Co., Ltd. does not guarantee the accuracy of the information
above. In case of doubt or uncertainty, we recommend that you check with the
authorities or official certification organizations of the relevant countries.