User's Manual
7
Rear Panel/Monitor Connection/Power
To connect the VCR and monitor, use cable type (multi-Cable) appropriate to your monitor.
Connect the VCR to the monitor as shown:
DC 12V
INPUT
REMOTE
SENSOR
INPUT
ANTENNA
1. ANTENNA
2. REMOTE SENSOR INPUT
3. DC 12V INPUT
To provide power for the VCR, connect the
small plug end of the power harness on the
back of the VCR.
Blue: This wire connects to a circuit that turns
on and off with the key.
Red: This wire connects to the battery or a
constant power source.
Black: This wire connects to a good factory
ground wire or a metal part of the chassis.
4. IN FROM ANT
Use to input cable or antenna signal.
5. OUT TO TV
Use to output VCR signal to a external TV
(if you want).
2
3
4
5
1
Installation
6
Front Panel
POWER
EJECT RECSTOP
PLAY
F.F
VIDEO AUDIO
LINE IN 2
POWER REC SLP HEAT
DEW
RL
REW
12345 6789101112 13
1. POWER
Turns VCR on and off.
2. Cassette Compartment
For cassette insertion/removal.
3. EJECT
Ejects cassette.
4. STOP
Stops tape movement.
5. REC
Starts recording.
6. SP/SLP Indicator
Lit when VCR is recording in
SLP mode.
7. DEW/HEAT Indicator
When DEW/HEAT indicator is blinking
and ÒDEW/HEATÓ is displayed on the
monitor screen, the VCR will not be
able to work, which shows the VCR is
under a high moist circumstance or
VCR is overheated. Then the VCR will
turn to standby and dry itself. When
moisture disappears, the VCR will
works normally.
8. Remote Sensor Eye
9. REW
Rewinds tape from stop mode.
10. PLAY
Press to begin playback.
11. FF
Fast forwards tape from stop mode.
12. VIDEO IN JACK
Use to input video signal from
connected equipment.
13. AUDIO IN L/R JACKS(LINE IN 2)
Use to input audio signal from
connected equipment.
The VCR can be mounted vertically, horizontally or at any angle in between with the
optional mounting brackets. The VCR cannot be mounted upside down or on its side.
VCR is sensitive to dirt and other contaminants. Do not mount the unit in direct sunlight,
on the floor near heavy traffic areas or where fluids are likely to spill on or in the unit.
The VCR is for 12Volt negative ground vehicles only.