User's Manual
Appendix B Clean the Optical Connectors
RFD01P Series Installation Manual v1.0 xcvi
Copyright © 2017, All Rights Reserved.
Measure the Optical Output and Connecting the Optical Connector
To measure the optical output
1 Using an optical power meter check the optical output.
2 If the optical output measurement result meets the reference value, clean the
connector again and connect it.
3 If the measurement result does not meet the reference value, discard the cable,
replace it with a new cable, and then clean the new one and connect it to the
system.
[Optical Power meter]
[LC/PC Plug]