User's Manual

Chapter 1 Before Installation
RFD01P Series Installation Manual v1.0 vii
Copyright © 2017, All Rights Reserved.
Installation Tools
The basic tools for installation are listed in the table below. The additional tools
required for each site need to be identified and prepared during a site survey before
starting installation.
Table 2. Basic Installation Tools
No.
Name
Specification
Purpose of use
1
Torque Driver
Apply a torque range
: 6~22 lbf·in
For fastening finger guard(M4)
Apply a torque range
: 20~90 lbf·in
For fastening RRU ground pressure
terminal(M6)
2
Screw Driver Bit
‘+’, No. 2
For fastening finger guard(M4)
‘+’, No. 3
For fastening RRU ground pressure
terminal(M6)
3
Screw Driver
‘+’, No. 2
For loosening M3, M4 screw
‘+’, No. 3
For loosening M6 screw
4
Torque Wrench
Apply a torque range
: 10~50 lbin
For tightening M6 Hex.Bolt and RF
connector of system(4.3-10 Type)
Apply a torque range
: 100~400 lbin
For tightening M10 Hex.Bolt and RF
connector of antenna(DIN Type)
5
Torque Wrench Spanner Head
Apply Hex. Bolt Head: 10 mm
(for 10~50 lbf·in)
For tightening M6 Hex.Bolt
Apply Hex. Bolt Head: 17 mm
(for 100~400 lbf·in)
For tightening M10 Hex.Bolt
Apply Hex. Bolt Head: 22 mm
(for 10~50 lbf·in)
For tightening RF connector of
system(4.3-10 Type)
Apply Hex. Bolt Head: 32 mm
(for 100~400 lbf·in)
For tightening RF connector of
antenna(DIN Type)
6
Spanner
10 mm
For loosening M6 Hex.Bolt
17mm
For loosening M10 Hex.Bolt
22 mm
For loosening RF connector of
system(4.3-10 Type)
32mm
For loosening RF connector of
antenna(DIN Type)
7
Ratchet Wrench
10 × 13/17 × 19 (4 in 1)
For fastening Hex. Bolt
8
Tape Measure
16 ft./150 ft.
Tape measure for length
measurement
9
Power Extension Cable
100 ft.
Basic tool