User's Manual
Chapter 3 Connecting Cables
RFD01P Series Installation Manual v1.0 lxxi
Copyright © 2017, All Rights Reserved.
Remove the cap of the optical connector before connecting.
- Before connecting the optical cable, check if the ferrule of the connector is soiled.
Be careful to keep the cutting section away from dust or foreign material.
If the cable is soiled with foreign material, do not blow to remove them.
- Make sure to clean the connector in accordance with the cleaning directions in
Annex.
- Do not touch the ferrule at the end of optical cable because it is easy to be
damaged.
2 Install a CPRI cable from the OFD (CDU port) to the RRU.
Figure 60. Connecting CPRI Cable_Cascade connection-oriented (1)
3 Separate the cap from the system side connector (L0, L1 port).
Figure 61. Connecting CPRI Cable_Cascade connection-oriented (2)
Cap
L0 Port
L0 Port
L1 Port
L1 Port
[Bottom View]
OFD (CDU Port)
or
RRU-0 (L1 Port)
CPRI Cable
Front
RRU-1 (L0 Port)
or
RRU-2 (L0 Port)
CPRI Cable
L0
L1
Ferrule
[Before Removing Cap]
[After Removing Cap]
Cap