User's Manual

T ROUBLESHOOTING
9.10
[No Answer]
The remote fax machine
has not answered after
several redial attempts.
Try again. Make sure that the
remote machine is operational.
NO. Not
Assigned
The one-touch or speed
dial location you tried to
use has no number
assigned to it.
Dial the number manually using
the number keypad or assign the
number. For storing a number,
see “Automatic Dialing” on
page 6.14.
[No Paper]
Add Paper
The paper tray has run
out of paper.
Load paper in the paper tray.
See page 1.12.
Operation Not
Assigned
You are doing in the Add/
Cancel operation, but
there is no jobs waiting.
Check the display to see if there
is any scheduled job. The display
should indicate them in Standby
mode, for example, Delay Fax.
[Paper Jam 0]
Open/Close Door
Paper has jammed in the
feeding area of the paper
tray.
Clear the jam. See page 9.4.
[Paper Jam 1]
Open/Close Door
Paper has jammed in the
paper exit area.
Clear the jam. See page 9.5.
[aper Jam 2]
Check Inside
Paper has jammed in the
fuser area.
Clear the jam. See page 9.4.
Power Failure
Power has turned off
then on and the
machine’s memory has
not been saved.
You need to start again the job
which you were trying to do
before the power failure.
Retry Redial?
The machine is waiting
for a specified time
interval to redial a
previously busy station.
You can press
Enter to
immediately redial, or
Stop/
Clear
to cancel the redial
operation.
[Stop Pressed]
The Stop/Clear button
is pressed during a copy
or fax operation.
Try again.
[Toner Empty]
The toner cartridge has
run out. The machine
stops printing.
Replace with a new toner
cartridge. See page 8.8.
[Toner Low]
The toner cartridge is
almost empty.
Take out the toner cartridge and
gently shake it. By doing this,
you can temporarily reestablish
printing operations.
Display Meaning Suggested solutions