User's Manual

Messages
124
Email address: enter your e-mail address.
SMTP server
: enter the IP address or domain name of
the server to be used for sending messages. Your e-mail
service provider can give you this information.
SMTP port
: enter the SMTP port number. Your e-mail
service provider can give you this information.
Protocol type
: specify an e-mail protocol type for the
incoming server, either
POP3 or IMAP4 . Contact your
e-mail service provider for more information.
The remaining options depend on the protocol type
setting.
When the protocol type is set to
POP3 :
POP3 server
: enter the IP address or domain name of
the server to be used for receiving messages. Your e-
mail service provider can give you this information.
POP3 port
: enter the POP3 port number.
APOP login
: when this option is checked, you can
connect to the server by using the APOP login scheme.
User ID
: enter your e-mail ID.
Password
: enter your e-mail password.
When the protocol type is set to
IMAP4 :
IMAP4 server
: enter the IP address or domain name of
the server to be used for receiving messages.
IMAP4 port
: enter the IMAP4 port number.
Retrieve headers
: set the number of headers you will
retrieve from the server.
Retrieve attachments
: when this option is checked, you
can receive attachments with e-mails from the server.
User ID
: enter your e-mail ID.
Password
: enter your e-mail password.
Messages
125
Email profile
You can configure various network settings that are
required when you send or receive e-mails.
Note : When an e-mail is being sent or retrieved from the
e-mail server, you are unable to change the e-mail
profile settings.
The following options are available:
Current profile : allows you to select one of the profiles.
Profile setting : you can configure up to 5 e-mail
profiles. For each profile, the following options are
available:
Profile name
: enter the name that you wish to assign to
the e-mail server.
APN
: enter the access point name used for the address
of the GPRS network.
Login ID
: enter the User ID required to connect to the
GPRS network.
Password
: enter the password required to connect to the
GPRS network.
DNS1
: enter the primary address required to connect to
the GPRS network.
DNS2
: enter the secondary address required to connect
to the GPRS network.