User's Manual

Setting Up the WAP Browser
8
The remaining options depend on the Bearer
setting, as indicated below.
When the bearer is set to Data
When the bearer is set to GPRS
Security
Data transmission mode. Choose
Secure to protect your data
against unauthorised access;
otherwise, choose
Non-Secure .
IP Address WAP gateway address required to
connect to the Internet.
Bearer Bearer to be used for each type of
network address accessed:
GPRS
or
Data .
Parameter Description
Login
Name
PPP server login ID.
Password PPP server password.
Dial-up
Number
PPP server phone number.
Data Call
Type
Data call type: Analogue or
ISDN .
Parameter Description
User Name
User ID required to connect to the
GPRS network.
Password Password required to connect to
the GPRS network.
APN Access point name used for the
address of the GPRS network
gateway.
Parameter Description
Setting Up the WAP Browser
9
Note : The WAP Browser settings may vary,
depending on the service provider. Contact
your service provider for further information.
3. After selecting each of these settings, a dialog
box is displayed; you can either enter the
information required or choose between given
options. When you are satisfied with your input,
press the
OK soft key.
4. When you have finished configuring the WAP
Browser, press the key or the right soft
key.