User's Manual

DB2/ 30119155.1

DRAFT 04/12/16 5:16PM 4:05PM

MODULE DISCLOSURES – QUICK START GUIDE

FCC REGULATORY DISCLOSURES

This device complies with Part 15 of the FCC`s Rules. Operation is subject to the following two

Conditions: (1) This device may not cause harmful interference, and (2) This device must accept any

interference received, including interference that may cause undesirable operation

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur

in a particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and receiver.

 Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

 Consult the dealer or an experienced radio/ TV technician for help.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.

This equipment should be installed and operated with a minimum distance of 20cm between the

transmitter’s radiating structure(s) and the body of the user or nearby persons.

This module is intended for OEM integration. The OEM integrator is responsible for FCC compliance and

compliance with all applicable regulations including those for modular transmitters 47 C.F.R. 15.212.

The OEM product must comply with all applicable labeling requirements including those contained in 15

C.F.R. 15.19. The OEM is solely responsible for certification and testing and labeling of its own products.

In addition to any independently required labels, the OEM shall also affix to the outside of a device into

which the module is installed a label referring to the enclosed module. This exterior label should be

prepared in a legible font and permanently affixed and using the wording “Contains Transmitter Module

FCCID: A3LSIP005AFS30

The OEM is required to ensure that the end product integrates this module so as to maintain a minimum

distance of 20 cm between the equipment’s radiating structure(s) and the body of the user or nearby

persons. The OEM shall also advise its end user of this requirement as required by applicable rules.

The OEM shall require that the end user of its product be informed that the FCC radio frequency

exposure guidelines for an uncontrolled environment can be satisfied. The OEM shall further inform its

PAGE 1
MODULE DISCLOSURES – QUICK START GUIDE FCC REGULATORY DISCLOSURES This device complies with Part 15 of the FCC`s Rules. Operation is subject to the following two Conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
end user that any change or modifications to this module not expressly approved by the manufacturer will void the warranty and the users’ authority to operate the equipment. INDUSTRY CANADA REGULATORY DISCLOSURES INDUSTRY CANADA STATEMENT This device complies with Industry Canada license-exempt RSS standard(s).
PAGE 3
EU REGULATORY DISCLOSURES CE STATEMENT * The following statement must be supplied with each product but can be printed in the user manual, the packaging, or provided as a separated leaflet. Hereby, Samsung declares that this IoT Module is in compliance with the essential requirements and other relevant provisions of Article 3 of the R&TTE Directive 1999/5/EC, 2004/108/EC and RoHS directive 2011/65/EU. “The declaration of conformity may be consulted at [www.artik.io/]” DB2/ 30119155.