User's Manual

User’s Manual
http://www.exoatletasia.com
ExoAtlet
Ⓡ
II 60 / 84 Ver 1.0 (2019.03.29.)
Figure 66
After pressing “Walking” button on Training screen exoskeleton will perform 3
beeping signals and then will wait for the patient to start movement. You will be
able to see the chosen mode in the bottom side of “Training” section. Patient
should try to move his left leg forward to initiate first step. If patient exceeds the
chosen effort limit exoskeleton will immediately make a step with left leg and then
stop. After finishing first step, patient should try to make a step with right leg and
so on. In order to stop walking you should press “Stop motion” button on Tablet
PC or button on the left handle. After it patient will have to initiate one last step
to get exoskeleton into standing pose. After finished, it will beep one more time
to show that device is ready for the next motion. If you will press stop button
before first step exoskeleton will immediately return to standing pose waiting for
the next motion.
Warning – initiation by effort should be used only with patients that can move their
lower limbs by themselves.
Warning – if patient needs to initiate, for example, step with left leg he should
provide an effort only with left leg.
3) Walking on place
After pressing “Walking on place” button you will get access to the parameters of
walking on place.
Press “Back” button in top left side of the screen to leave the settings without any
changes.
You can adjust various parameters (see Figure 67):