User's Manual

ManualsBrandsSamsung Electronics ManualsElectronicsARTIK-0710

HOST%INSTALLATION%MANUAL%

FCC#ID:#A3LSIP007AFS00#

According#to#the#KDB#996369,#Question#11,#A#modular#transmitter#may#be#certified#when#the#

connection#to#the#antenna#is#made#through#a#host’s#printed#board#microstrip#trace#layout#to#an #

external# connector,# trace# antenna,# or# component# (chip)# antenna# on# a# printed# circuit# board#

(herein#referenced#as#“trace#design”).#This#can#be#extended#to#include#passive#parts#for#antenna#

attenuation#p adding,#impedance#matching,#or#providing#test#ports.#Other# components,#such# as#

amplifiers#and#active#drivers,#are#not#considered#a#trace#layout#an d#must#be#contained#on#the#

module.#

OEM#instructions#(see#Clause#II#in#KDB#Publication#996369# D01)#for#all#trace#designs#approved#

with#the#module#must#be#followed#as#below.#

A)%Trace%layout%and%dimensions%including%specific%designs%for%each%type:%

1)#Layout#of#trace#design,#parts,#antenna,#connectors,#and#isolation#requirements;#

CIRCUIT%Design#

# # # WLAN/Bluetooth#Antenna#

# # # Zigbee#Antenna#

# #

Summary of content (5 pages)

PAGE 1
HOST INSTALLATION MANUAL FCC ID: A3LSIP007AFS00 According to the KDB 996369, Question 11, A modular transmitter may be certified when the connection to the antenna is made through a host’s printed board microstrip trace layout to an external connector, trace antenna, or component (chip) antenna on a printed circuit board (herein referenced as “trace design”). This can be extended to include passive parts for antenna attenuation padding, impedance matching, or providing test ports.
PAGE 2
HOST INSTALLATION MANUAL FCC ID: A3LSIP007AFS00 PCB Layout WLAN/Bluetooth Antenna Trace Information Length: 4.70000e+00 mm Width: 8.50000e+001 mm Characteristic Impedance: 51.60 ohm Effective Dielectric Constant: 3.
PAGE 3
HOST INSTALLATION MANUAL FCC ID: A3LSIP007AFS00 PCB Information
PAGE 4
HOST INSTALLATION MANUAL FCC ID: A3LSIP007AFS00 b) Appropriate parts by manufacturer and specifications. Bill of Materials ERP code Part name CNSMA602001 SMA-602-001 2 CNUFLRSMT1 UFL-R-SMT-1 2 ET160715-03 U.FL Connector SMA Connector Qty 2 ERP Description FEMALE,SMA-Straight-PCB JACK,DIP,5P,SMA-602-001 FEMALE, SMD, 3pin, U.FL-R-SMT-1 MHF PLUG CABLE, U.
PAGE 5
HOST INSTALLATION MANUAL FCC ID: A3LSIP007AFS00 RF Cable c) Test procedures for design verification and Production test procedures for ensuring compliance. To meet the requirement as certified modular, output power from the module via circuit layout must be equal or lower than followings. MODE ZIGBEE WLAN 2.4GHz WLAN 5GHz FREQUENCY (MHz) 2405 2475 2412 2462 5180 5240 OUTPUT POWER 7.63 dBm 24.15 dBm 15.