User's Manual Part 1

NE for Enterprise PSW.indd 4-5
10/16/2015 9:05:00 AM
Radio Frequency (RF) Energy
Understanding How Your 4G LTE Network Extender
Operates
Your Network Extender functions as a radio transmitter
and receiver. When it is turned on, it receives and
transmits radio frequency (RF) signals. When you use
your Network Extender, the system handling your call
controls the power level. This power can range from
50mW to 500mW peak for Licensed band (2x250mW) and
Unlicensed band (2x250mW).
Knowing Radio Frequency Safety
The design of your Network Extender complies with
updated NCRP standards described below:
In 1991–92, the Institute of Electrical and Electronics
Engineers (IEEE) and the American National Standards
Institute (ANSI) joined in updating ANSI’s 1982 standard
for safety levels with respect to human exposure to
RF signals. More than 120 scientists, engineers and
physicians from universities, government health agencies
and industries developed this updated standard after
reviewing the available body of research.
In 1993, the Federal Communications Commission (FCC)
adopted this updated standard in a regulation. In August
1996, the FCC adopted a hybrid standard consisting
4
of the existing ANSI/IEEE standard and the guidelines
published by the National Council of Radiation Protection
and Measurements (NCRP).
For more information about RF exposure, visit the FCC
Web site at www.fcc.gov.
FCC Radio Frequency Emission
This device meets the FCC Radio Frequency Emission
Guidelines.
FCC ID number: A3LSLS-BU10A0.
FCC Statement
This product has been tested and complies with the
specifications for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not
installed and used according to the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which is found by turning the equipment off and on, the
user is encouraged to try to correct the interference by
one or more of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment
and receiver.
● Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV
technician for help.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation.
FCC Caution: Any changes or modifications not expressly
approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
Important Note.
FCC Radiation Exposure Statement
To ensure the safety of users, the FCC has established
criteria for the amount of radio frequency energy various
products may produce depending on their intended
usage. This product has been tested and found to comply
with the FCC’s exposure criteria.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
The installation of the base unit should allow at least
30 centimeters between the base and persons to be
in compliance with FCC RF exposure guidelines.
Please read the following important safety notices and
instructions before installing or using the product.
1. Follow all warnings and instructions marked on the
product.
2. Unplug this product from the wall outlet before
cleaning. Do not use liquid cleaners or aerosol
cleaners. Use an anti-static cleaning pad for
cleaning.
3. Do not use this product near water.
4. Do not place this product on an unstable cart,
stand or table. If the product falls, it could be
seriously damaged.
Section 1: Product Safety 5