User's Manual

ManualsBrandsSamsung Electronics ManualsComputers & AccessoriesWireless Mouse

Brand: Samsung

Model: AA-SM7PWR

AA-SM7PWRB / AA-SM7PWRS /

AA-SM7PWRN / AA-SM7PWRP

Wireless Mouse

BlueTrace Mouse

w/Nano Receiver

USER'S GUIDE

Ver.:1.00

Model: AA-SM7PWRB+AA-SR7PWUB, AA-SR7PWU

CAUTION: To use this product properly, please read the user's guide before installing.

Summary of content (5 pages)

PAGE 1
Brand: Samsung Model: AA-SM7PWR AA-SM7PWRB / AA-SM7PWRS / AA-SM7PWRN / AA-SM7PWRP Wireless Mouse BlueTrace Mouse w/Nano Receiver USER'S GUIDE Ver.:1.00 Model: AA-SM7PWRB+AA-SR7PWUB, AA-SR7PWU CAUTION: To use this product properly, please read the user's guide before installing.
PAGE 2
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 3
Functional Introduction ON/OFF Switch Connect Button LED Indicator Scrolling Wheel Right button Battery Cover Left button Nano Receiver Installing the batteries Step 1: Take the battery cover off. Step 2: Insert the battery as shown inside the battery compartment. Step 3: Replace the cover. Pull AA Battery **Warning: *Please insert the battery with the correct position according to the instruction marked on the mouse.
PAGE 4
Setup the Connection between the Receiver and the Mouse 1. Insert the battery into the mouse, then follow the steps below. 2. In the meantime, open the mouse under the cover, take the nano receiver out. 3. Plug the Nano receiver into the USB port on your computer. 4. If the mouse does not work, please put it into pairing mode. 5. Pairing: Re-plug the receiver into the USB port on your computer, then press the connect button on the mouse. If the mouse does not work after 10 seconds, pair them again.
PAGE 5
LED Indicator *Mouse Indicator LED is on for 10 sec. Power ON LED Blinking During Pairing (LED OFF when paired or failed after 10 sec.) LED Blinks for 10 sec.