Installation Manual
Table Of Contents
- Contents
- List of Figures
- List of Tables
- Preface
- Chapter 1 Before Installation
- Chapter 2 Installing System
- Chapter 3 Connecting Cables
- Chapter 4 Inspect the Installation
- Appendix A Acronyms
- Appendix B Standard Torque
Confidential
Chapter 3 Connecting Cables
Samsung 5G Station Outdoor Installation Manual v1.0 52
Copyright © 2020, All Rights Reserved
Figure 44. Checking a LED (1)
- After turning on the CPE Outdoor, connect an auxiliary battery. It will operate
in installation mode, and you can check the 5G signal strength with the LED.
If there is nothing wrong, disconnect the auxiliary battery and connect the cable.
- After completing the installation, use the RESET key to switch from installation
mode to regular mode. If you find any problem in regular mode, switch to
installation mode again and recheck the LED.
- Refer to Table 22. LED Indication for more specific details on the LED status.
3 After checking whether the CPE Outdoor is in working order, close the LED
cover.
LED Cover