User's Manual
Table Of Contents
- Samsung BISCOTTO
- Section 1: Getting Started
- Section 2: Understanding Your Device
- Section 3: Connecting Your Device
- Section 4: Home Page
- Section 5: Network Page
- Section 6: Securing Your Device
- Section 7: Configuring Your Device
- Section 8: Messaging on Your Device
- Section 9: Health and Safety Information
- Exposure to Radio Frequency (RF) Signals
- Specific Absorption Rate (SAR) Certification Information
- FCC Part 15 Information to User
- Radio Frequency (RF) Energy
- Knowing Radio Frequency Safety
- FCC Radio Frequency Emission
- Samsung Mobile Products and Recycling
- UL Certified Travel Charger
- Battery Use and Safety
- Care and Maintenance
- Operating Environment
- Restricting Children's Access to Your Wireless Mobile Device
- FCC Notice and Cautions
- Other Important Safety Information
- Section 10: Warranty Information
- Index
DRAFT
Internal Use Only
Network Page 25
Note:
These addresses are part of a private address range for
use in private networks, and should be suitable in most
applications. If your network has a requirement to use a
different IP addressing scheme, you can make those
changes in this menu.
•
MAC Address
(display only): Displays the device MAC address.
DHCP Server
When enabled, the DHCP (Dynamic Host Configuration
Protocol) server allows your Mobile HotSpot to acquire
network configuration settings from your Wireless Provider’s
network automatically.
•
DHCP Server enable
: Click or touch to enable.
•
DHCP Address Range
: The range of IP addresses reserved for
use by the HotSpot’s DHCP server table. If a device with a static IP
address wants to connect to Mobile HotSpot’s network, the static
IP should be outside of the DHCP address range. Most devices do
not have a static IP.
•
DHCP Lease Time (in hour)
: Enter a value to assign a minimum
amount of time (in hours) for which the DHCP server will retain
the IP Address that will be allocated to a particular device.
DHCP Server Buttons
•
Apply
: Select to update the settings and apply them.
•
Reset
: Select to revert the settings to their previous values.
Data Limit
•
Data Limit
: Allows you to set a data limit for connected devices
on your current network. This action limits how much data can be
used by the external device. Enable the
Data Limits
checkbox,
enter the amount of data in GB and/or MB, then tap
Apply
.
Data Limit Buttons
•
Apply
: Select to update the settings and apply them.
•
Reset
: Select to revert the settings to their previous values.